Roland TD-9 User Manual download pdf (Page 7)

IMPORTANT: Make sure you have the two inputs set to trigger the appropriate sounds for

each kit:

Ride Input HEAD = Ride Bow Sound

Ride Input RIM = Ride Edge Sound

Other Input HEAD = Ride Bell Sound

Other Input RIM = Ride Edge Sound (Same as Ride RIM input)

Notes for using the Surge Dual-Zone Ride Cymbal:

Use the included Y-cable on the module end of the ride’s stereo cable. Plug the black tip plug into

the any input (other than #2) and the orange ring plug into any other input (other than #2).

Alternately, you can use Input #2 only which is a stereo input (the only one on the TMC-6 without the

Y-cable. Use the following settings if you connect the Ride to Input #2.

NOTE: You must set the pad type to P12 to be able to use the Bow and Rim sounds. You will have

to adjust the Head and Rim settings independently.

Type Sens Thold Curve Scan ReTrg Can. Mask Xtalk

Ride Head

P12 8 4 Linear 2.5 8 8 40

Ride Bell

P12 12 0 Linear 2.5 8 8 40

YAMAHA™ DRUM MODULE SETTINGS

Yamaha also offers a few very popular drum modules in the DTX line of electronic drums such as the

DTXTREME IIS and the DTXPRESS III. The Surge Splash, Crash, China, and Hi-Hat Cymbals are

supported when using the PCY-80 trigger input setting. Surge Ride Cymbals will work but are not

supported at this time.

DDRUM™ DRUM MODULE SETTINGS

Ddrum modules are not officially supported, but may work with Surge Cymbals using mono inputs. E-

mail us if you have one of these modules and want to report your trigger settings.

Note: The Ddrum cymbal inputs are not compatible with the choke-able or dual-zone cymbals. You

will only get one zone from all Surge Cymbals.

1 2 3 4 5 6 7 8 9 10 11

No comments

Roland TD-9 User Manual Page 7