Thank you, and congratulations on your choice of the TD-20K Roland Drum System. TD-20K_BK.eps 202 Copyright © 2005 ROLAND CORPORATIONAll rights reserv
10 KD-120 (V-Kick Trigger Pad) The head is an expendable item that eventually will wear out and need to be replaced. Replace the head when the follow
11 PD-125/PD-105 (V-Pad) fig.15.e The only difference between the PD-125 and the PD-105 is the diameter.* The figure shows the PD-125. * Do not appl
12 PD-125/PD-105 (V-Pad) When adjusting, use the included tuning key. On the PD-125/105, adjusting the head tension affects only the head response, a
13 CY-15R/CY-14C (V-Cymbal Ride/Crash) CY-15R (Ride) fig.19.e Diameter: 15 inches CY-14C (Crash) fig.20.e Diameter: 14 inches Contents of the Packag
14 CY-15R/CY-14C (V-Cymbal Ride/Crash)1. Use the included tuning key to tighten the stopper bolt. The stopper keeps the V-Cymbal from turning, and pr
15 Assemble the TD-20K Using the built-in connection cables of the MDS-20, connect the pads, cymbals, hi-hat, kick trigger pad, and percussion sound
16 Playing Methods fig.26.e Head Shots Hit only the head of the pad. With certain snare sounds, playing position will change the nuance of the sound.
17 Playing Methods fig.30 Bow Shot This is the most common playing method, playing the middle area of the cymbal. fig.31.e Edge Shot This playing me
18 Specifications Pad Size: 12 inchesDimensions: 490 (W) x 400 (D) x 500 (H) mm19-5/16 (W) x 15-3/4 (D) x 19-11/16 (H) inchesWeight: 7.7 kg17 lbsAcce
19 SpecificationsThis product complies with the requirements of European Directive 89/336/EEC.For EU CountriesTD-20K_e.book 19 ページ 2006年12月7日 木曜日 午前9
2 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. ...
04122290 06-01-3N *04122290 -03* As of November 1, 2006 (ROLAND)Information When you need repair service, call your nearest Roland Service
3 Important Notes 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: Placement 354a
4 Assemble the Drum Stand. About the Stand, refer to the MDS-20 Owner’s Manual.• Do NOT open the legs of the stand more than 135 degrees. The distanc
5 KD-120 (V-Kick Trigger Pad) * This package does not include a kick pedal. Use with a commercially available kick pedal installed on the KD-120.* I
6 KD-120 (V-Kick Trigger Pad)1. Place the KD-120 pad, with the head surface facing downward, on a flat surface such as the floor. 2. Use the included
7 KD-120 (V-Kick Trigger Pad)5. Loosen the T-bolts for the stand and mount the legs on the stand.Install the legs as shown in the figure so that the
8 KD-120 (V-Kick Trigger Pad) With the KD-120, you can also play using a twin (double kick) pedal.Set this up so that the striking points of the two
9 KD-120 (V-Kick Trigger Pad) The head tension of the KD-120 can be adjusted.Use the included tuning key to adjust the tension.In general, a tension
Comments to this Manuals