Roland TD-6KX Owner's Manual

Thank you, and congratulations on your choice of the Roland Drum System TD-6KX.202Copyright © 2006 ROLAND CORPORATIONAll rights reserved. No part of

10 USING THE UNIT SAFELY When attaching the PD-105 to the rod, be sure to tighten the stand fixing screw securely. If it remains loose, the pad could

11 USING THE UNIT SAFELY • Do not apply excessive force to the sensor located below the center of the head of the PD-85. Doing so can interfere with

12 USING THE UNIT SAFELY1. Use the tuning key supplied with the FD-8 to tighten the tuning bolts. Tighten the bolts to keep the space even all around

13 USING THE UNIT SAFELY When the Head Should Be Replaced The head is an expendable item that eventually will wear out and need to be replaced. Repl

14 USING THE UNIT SAFELY fig.CY-8.e When mounting the CY-5 on an L-Rod (pad mount), use ONLY the attachment set as shown below.(Use the tuning key

15 USING THE UNIT SAFELY fig.CY-8.e 1. Use a tuning key to tighten the stopper bolt. The stopper keeps the cymbal pad from turning, and prevents the

16 USING THE UNIT SAFELY1. Use the tuning key supplied with the FD-8 to tighten the stopper bolt. The stopper keeps the CY-12R/C from turning, and pr

17 USING THE UNIT SAFELY Bow Shot This is the most common playing method, playing the pad face of the cymbal. It corresponds to the sound of the “hea

18 USING THE UNIT SAFELY You can use up to 11 pads at the same time. * For more information, refer to TD-6V Owner’s Manual p. 33. Adding a Cymbal Tri

19 USING THE UNIT SAFELYAs of August 1, 2006 (ROLAND)Information When you need repair service, call your nearest Roland Service Center or authorized

2 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. ...

C5100050 2YG The TD-6KX’s trigger parameters have been set at the factory for the included pads.Normally there is no reason to make further

3 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: Placement 354a • Do not expose

4 ❑ TD-6V (Percussion Sound Module) x 1 ❑ KD-8 (Kick Trigger Pad) x 1 ❑ FD-8 (Hi-Hat Control Pedal) x 1 ❑ PD-105 (Snare Pad) x 1 ❑ PD-85 (Tom Pad) x

5 USING THE UNIT SAFELY . 921 Using the provided cables, connect the pads.Connect the L-shaped plugs of the included cables to the pads. To prevent m

6 USING THE UNIT SAFELY fig.KD-8.e 1. Remove the screws attached to the reverse side of the KD-8’s trigger. fig.KD-Assy01 2. Pull out the stand in th

7 USING THE UNIT SAFELY1. Loosen the stand’s anchor bolts and remove the foot plate. fig.KD-Assy06 2. Set the kick pedal so that the entire bottom su

8 USING THE UNIT SAFELY fig.FD-8.e • The tips of the anchor bolts are sharp. Handle with care.• When using on flooring, the anchor bolts may damage t

9 USING THE UNIT SAFELY • Do not apply excessive force to the sensor located below the center of the head of the PD-105. Doing so can interfere with