Roland LEC-540 Setup Guide Page 52

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 51
6. Installing the Blade
50
3.
Install the blade holder.
Loosen the screw shown in the gure.
Support the screw from below and insert
the blade holder.
If installed without supporting the screw in this way,
cutting quality may become poor.
w
Tighten the screw.
Tug the blade holder upward to make sure it does
not come loose.
Close the front cover.
Press
.
Important Note on the Handling and Use of the Cutting Carriage
While the blade holder is not attached, leave the screws of the cutting carriage loose. If you leave them
tightened rmly, the hole to insert the blade holder is gradually getting smaller, which will make it dicult
to attach the blade holder.
Insert until the collar is
ush with the surface.
Support it from below.
Page view 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Comments to this Manuals

No comments