Roland VS8F-3 Owner's Manual download pdf (Page 27)

Effect Algorithm

EXP (Expander)

If the input volume drops below the specified threshold, this will expand the dynamic range of the output signal.

REVERB

Adds reverberation.

Parameter (full name)

Setting Function

Sw (Switch)

OFF, ON Turns the expander on or off.

THRE (Threshold) -80.0~0.0 dB

Sets the volume at which the expander starts working

RATIO 1:1.00~1:16.0, 1:

∞

Sets the ratio at which the output is increased when the input level has dropped below the

threshold level (THRE).

ATK (Attack) 0.0~800.0 ms

Sets the time until when the expander starts working after the input level drops below the

threshold level (THRE).

REL (Release) 50~8000 ms

Sets the time until when the expander stops working after the input level exceeds the

threshold level (THRE).

Parameter (full name)

Setting Function

TYPE

ROOM1, ROOM2,

HALL1, HALL2,

PLATE

Type of reverb

ROOM1: Typical room reverb

ROOM 2: Room reverb with a softer tone than ROOM1

HALL1: Typical hall reverb

HALL2: Hall reverb with a softer tone than HALL 1

PLATE: Plate reverb

SIZE (Room Size) 5~40 m Sets the size of the room.

PRE-DLY (Pre-Delay) 0~200 ms Sets the time until the reverb sound appears.

TIME (Reverb Time) 0.1~32.0 sec. Sets the time length of the reverb sound.

ER LEVEL

(Early Reflection Level

0~100 Sets the volume of the early reflection.

DIFFUSE (Diffusion) 0~100 Sets the extent of diffusion of the early reflection sound.

DENSITY 0~100 Sets the density of the reverb sound.

LF DAMP GAIN -36.0~0.0 dB Sets the degree of attenuation of the reverb in the Low frequency band.

LF DAMP FREQ 20~2000 Hz Sets the frequency on which the reverb starts attenuating in the Low frequency band.

HF DAMP GAIN -36.0~0.0 dB Sets the degree of attenuation of the reverb in the High frequency band.

HF DAMP FREQ 200~20000 kHz Sets the frequency on which the reverb starts attenuating in the High frequency band.

HCF (High Cut Frequency) 200~20000 kHz Sets the frequency for which the High frequency band elements of the reverb are cut.

L/R BAL (L/R Balance) L63~C~R63 Sets the volume balance between the left-side sound and the right-side reverb sound.

WET LEVEL -

∞

, -80.0~6.0 dB Sets the volume of the reverb sound.

DRY LEVEL -

∞

, -80.0~6.0 dB Sets the volume of the direct sound.

VS8F-3_e.book 27 ページ２００４年３月３１日　水曜日　午後４時３８分

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments

Roland VS8F-3 Owner's Manual Page 27

Comments to this Manuals

Related products and manuals for Recording Equipment Roland VS8F-3