Roland MOBILE CUBE Owner's Manual download pdf (Page 10)

Panel Descriptions

Rear Panel

988

7. Security Slot ( )

http://www.kensington.com/

8. Grounding terminal

927

Depending on the circumstances of

a particular setup, you may experience

a discomforting sensation, or perceive that

the surface feels gritty to the touch when

you touch this device, microphones

connected to it, or the metal portions of other

objects, such as guitars. This is due to an

infinitesimal electrical charge, which is

absolutely harmless. However, if you are

concerned about this, connect the ground

terminal (see figure) with an external ground.

When the unit is grounded, a slight hum may

occur, depending on the particulars of your

installation. If you are unsure of the

connection method, contact the nearest

Roland Service Center, or an authorized

Roland distributor, as listed on the

“Information” page.

Unsuitable places for connection

• Water pipes (may result in shock or

electrocution)

• Gas pipes (may result in fire or explosion)

• Telephone-line ground or lightning rod

(may be dangerous in the event of

lightning)

* Due to interference from external devices or the power

outlet to which you're connected, a noticeable amount of

noise may be emitted from this unit.Connecting the ground

terminal with an external ground can reduce such noise.

9. Battery Compartment

Insert six AA batteries. Refet to “Inserting

Batteries”(p. 5).

* Use only manganese or alkaline batteries (LR6).

You cannot use any other type of battery.

The use of alkaline batteries are recommended as the unit’s

power consumption is relatively high.

Switching the Power On and Off

941

* Once the connections have been completed, turn on power

to your various devices in the order specified. By turning on

devices in the wrong order, you risk causing malfunction

and/or damage to speakers and other devices.

1. Make sure that all volume controls on the

MOBILE CUBE and connected devices are

set to 0.

2. Turn on all the devices connected to the

MOBILE CUBE

’s INPUT and AUX IN jacks.

3. Turn on the

MOBILE CUBE

4. Adjust the volume levels for the devices.

5. Before switching off the power, lower the

volume on each of the devices in your

system and then TURN OFF the devices in

the reverse order to which they were

switched on.

921

* To prevent malfunction and/or damage to speakers or other

devices, always turn down the volume, and turn off the

power on all devices before making any connections.

MOBILE_CUBE_egfiepn.book Page 10 Wednesday, March 5, 2008 10:35 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comments to this Manuals

No comments

Roland MOBILE CUBE Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Audio amplifiers Roland MOBILE CUBE