Roland M-10E Owner's Manual download pdf (Page 19)

OPERATION

941

* Once the connections have been completed (p. 16), turn on power to your various

devices in the order specified. By turning on devices in the wrong order, you risk

causing malfunction and/or damage to speakers and other devices.

1. Switch off the M-10E and all the units to be connected.

2. Make all the necessary connections. Set the BALANCE knob of each channel to

the center position and the SENS knob of each channel to the “+4” position. Set

each Channel VOLUME slider to “0” (the marked position) and the MASTER

Volume slider to the “-∞” position.

943

* Always make sure to have the MASTER volume level turned down before

switching on power. Even with the volume all the way down, you may still hear

some sound when the power is switched on, but this is normal, and does not

indicate a malfunction.

fig.6

3. Switch on all the units connected to the M-10E.

4. Switch on the M-10E.

944a

* When operating on battery power only, the unit’s indicator will become dim when

battery power gets too low. Replace the battery as soon as possible.

5. Slowly raise the MASTER Volume slider to an appropriate level.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Roland M-10E Owner's Manual Page 19