Roland MVS-12 Owner's Manual download pdf (Page 14)

Connecting External Equipment

* To prevent malfunction or damage to video monitors or other devices, always turn off the power on all devices before making any

connections.

When you’re using the unit as a multi-viewer, connect monitor equipment to the MULTI-OUT (MENU) connectors. The MVS-12 is

equipped with RGB (D-Sub 15-pin) and HDMI output connectors, and both connectors output the same video signal. Select the

connector to match the monitor equipment you’re connecting.

When you’re using the unit as a matrix switcher, the PREVIEW connector in the MATRIX OUT section outputs the four pictures

output from MATRIX OUT 1 through 4 as a four-way split screen. Connecting a monitor device here enables you to preview all

pictures output from MATRIX OUT 1 through 4.

fig.monitor-out.eps

* For information on the output resolution of the MULTI-OUT (MENU) connectors, refer to “Main Specifications” (p. 37). Connect monitor

equipment that is compatible with the output from the MVS-12.

* The signal output from the PREVIEW connector in the MATRIX OUT section is NTSC or PAL.

About Ferrite Cores

Two ferrite cores are included with the MVS-12. Attach them to the two ends of the HDMI cable being connected to the MVS-12.

Clamp each ferrite core onto the cable at a location near the plug at the end of the cable, pressing down on the ferrite core until it

clicks closed.

fig.HDMI-ferrite-core.eps

* When attaching ferrite cores, be careful to avoid pinching your fingers.

* When connecting an HDMI device to the MVS-12, use an HDMI cable on which ferrite cores are attached.

Connecting Output Devices

Connecting Monitors

1234

5678

9101112

1234

5678

9101112

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Roland MVS-12 Owner's Manual Page 14