Roland MVS-12 Owner's Manual download pdf (Page 21)

Use As a Multi-Viewer

You can synchronize operation of the MVS-12 with the LVS-800 and display the channel-selection status on a monitor.

1. Connect the output of the LVS-800.

Connect the output from the LVS-800 (preview and final output) to the VIDEO INPUT connectors on the MVS-12.

* By default, MIDI OUT on the LVS-800 is set to [THRU]. Change the setting to [OUT].

fig.connect-LVS800.eps

2. Connect the LVS-800 and the MVS-12 using MIDI.

Connect the MIDI output from the LVS-800 to the MIDI IN connector on the MVS-12.

* Set the MIDI channels and device IDs to matching values, and set the MVS-12 to receive MIDI signals from the LVS-800.

fig.MIDI-connect.eps

3. Operate the LVS-800.

Operate the LVS-800 to change the channel selections and switch the video. A box appears around the video displayed on the

monitor connected to the MVS-12.

• Preview

This is the video selected on the mixer’s inactive bus. A green box is displayed around the picture.

• Program

This is the video currently being output. A red box is displayed around the picture.

If the same channel is selected for Preview and Program, the two boxes overlap. The color that is displayed is red.

The red and green boxes are not displayed at multiple locations even when the MVS-12 has been set to display a single channel at multiple

locations. Only a single box of each color is displayed.

When the system version of the LVS-800 is 1.0, only operation in the A/B mode is supported. With system version 1.1 or later, operations in the

PGM-PST mode,the LVS mode and Picture in Pictue are also supported. The system version of your LVS-800 mixer is displayed during startup on a

monitor connected to the LVS-800’s A/B MIX PVW jack.

Synchronizing with Operation of the LVS-800

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

No comments

Roland MVS-12 Owner's Manual Page 21