Roland AXIS-1 User Manual download pdf (Page 27)

2-1 Before Installing

Chapter 2 Installation

Overview of the installation Porcedure

This in an overview of the installation procedure. For the specic steps required to install this unit, see the following section.

Important Notes on Installation Operations

 Before installing, clean away any cutting waste and any soiling on the installation surface. Any foreign

matter that becomes caught between components may reduce accuracy.

Forseveralparts,theinstallationlocationisdeterminedbybuttingthepartushagainstasurface.

Because accuracy can be reduced by improper contact when doing this, carry out such procedures

especially carefully.

About Use in Combination with an ATC Unit

If you intend to use this unit in combination with an ATC unit, then install the ATC unit rst, before you install this unit. If this

unit is already installed on the machine, then it must rst be removed.

Also, the ATC unit includes a Z-origin sensor as well, but it is not used, so remove it. When you're using this unit in combina-

tion with an ATC unit, attach only the Z-origin sensor for this unit.

About VPanel Settings

VPanel automatically detects this unit when it is installed. You don't need to make any special settings.

Set Up the Modeling machine

Finish installing the modeling machine, installing and setting up the program and other software, and connecting the

modeling machine to the computer. Also, nish installing the optionally available T-slot table at this time.

Install the ATC Unit

f you intend to use this unit in combination with an ATC unit, then install the ATC unit rst.

Install the Rotary Axis Unit

Install the unit.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 79 80

No comments

Roland AXIS-1 User Manual Page 27