Roland PH-3 Owner's Manual download pdf (Page 17)

Changing the Battery

When the CH

ECK indicator goes dim or no

longer lights while an effect is on, it means

that the battery is nearly dead and must be

replaced.

Replace the battery following

the steps below.

* For best results (i.e., longest usable life)

use an alkaline type battery.

Loosen the thumbscrew at the front of

the pedal, then lift the pedal upwards to

open the unit.

* The thumbscrew can be left in the pedal

while changing the battery.

Remove the old battery from the battery

housing, and remove the battery snap

connected to it.

Connect the battery snap to the new bat-

tery, and place the battery inside the bat-

tery housing.

* Be sure to carefully observe the battery’s

polarity (+ versus -).

Slip the coil spring onto the spring base on

the back of the pedal, then close the pedal.

* Take care not to allow the battery snap cord to become

caught in the pedal, coil spring, or other places.

Finally, insert the thumbscrew into the

guide bush hole and fasten it securely.

Thumbscrew

Pedal

Spring Base

Coil Spring

Guide Bush

Hole

Battery Housing

Battery Snap

Cord

Battery

Snap

9V Battery

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Roland PH-3 Owner's Manual Page 17