Roland HP-307 Owner's Manual download pdf (Page 8)

IMPORTANT NOTES

Power Supply

• Do not connect this unit to same electrical outlet that is being used

by an electrical appliance that is controlled by an inverter (such as a

refrigerator, washing machine, microwave oven, or air conditioner),

or that contains a motor. Depending on the way in which the

electrical appliance is used, power supply noise may cause this unit

to malfunction or may produce audible noise. If it is not practical to

use a separate electrical outlet, connect a power supply noise filter

between this unit and the electrical outlet.

• Before connecting this unit to other devices, turn off the power to all

units. This will help prevent malfunctions and/or damage to speakers

or other devices.

• Although the LCD and LEDs are switched off when the POWER switch

is switched off, this does not mean that the unit has been completely

disconnected from the source of power. If you need to turn off the

power completely, first turn off the POWER switch, then unplug the

power cord from the power outlet. For this reason, the outlet into

which you choose to connect the power cord’s plug should be one

that is within easy reach and readily accessible.

Placement

• Using the unit near power amplifiers (or other equipment containing

large power transformers) may induce hum. To alleviate the

problem, change the orientation of this unit; or move it farther away

from the source of interference.

• This device may interfere with radio and television reception. Do not

use this device in the vicinity of such receivers.

• Noise may be produced if wireless communications devices, such as

cell phones, are operated in the vicinity of this unit. Such noise could

occur when receiving or initiating a call, or while conversing. Should

you experience such problems, you should relocate such wireless

devices so they are at a greater distance from this unit, or switch

them off.

• Do not expose the unit to direct sunlight, place it near devices that

radiate heat, leave it inside an enclosed vehicle, or otherwise subject

it to temperature extremes. Also, do not allow lighting devices that

normally are used while their light source is very close to the unit

(such as a piano light), or powerful spotlights to shine upon the same

area of the unit for extended periods of time. Excessive heat can

deform or discolor the unit.

• When moved from one location to another where the temperature

and/or humidity is very different, water droplets (condensation) may

form inside the unit. Damage or malfunction may result if you

attempt to use the unit in this condition. Therefore, before using the

unit, you must allow it to stand for several hours, until the

condensation has completely evaporated.

• Do not allow rubber, vinyl, or similar materials to remain on the unit

for long periods of time. Such objects can discolor or otherwise

harmfully affect the finish.

• Do not allow objects to remain on top of the keyboard. This can be

the cause of malfunction, such as keys ceasing to produce sound.

• Do not paste stickers, decals, or the like to this instrument. Peeling

such matter off the instrument may damage the exterior finish.

Maintenance

• To clean the unit, use a dry, soft cloth; or one that is slightly

dampened. Try to wipe the entire surface using an equal amount of

strength, moving the cloth along with the grain of the wood.

Rubbing too hard in the same area can damage the finish.

• Never use benzine, thinners, alcohol or solvents of any kind, to avoid

the possibility of discoloration and/or deformation.

• The pedals of this unit are made of brass.

Brass eventually darkens as the result of the natural oxidization

process. If the brass becomes tarnished, polish it using commercially

available metal polisher.

• Since wood will expand and contract depending on how it is used

and the environment in which it is located, products made of wood

may experience a gradual loosening of the screws over time.

To ensure that your piano remains in safe, optimal condition, you

should regularly check the tightness of the screws in the locations

shown in the illustration. If you find that any screws are loose, use a

screwdriver to tighten them.

Maintenance (Polished-finish pianos)

• Since your piano has a polished finish that is as delicate as that found

on finely crafted wooden furniture, it needs careful, periodic care.

• For regular dusting, use a soft, clean cloth and/or a piano-use

feather duster. Be sure to wipe gently. Even tiny granules of grit

can damage the surface of the unit if you use too much pressure

when wiping.

• If the cabinet gets dirty, wipe it with a soft cloth that has been

soaked with water, then squeezed dry. Afterwards, wipe it again

with a soft dry cloth. Do not use any cleaners or detergents, since

they might deteriorate the surface of the cabinet, and produce

cracks. Do not use dusting cloths that contain chemicals.

• If the cabinet’s surface loses its luster, wipe it thoroughly with a

soft cloth dampened with a little of the piano polishing liquid.

• About piano polishing liquid

• Use polishing liquid as directed by the instructions for the

product.

• Use only polishing liquid that is intended for use on polished-

finish pianos. Using any other polishing liquid may cause

scratches, deformation, or discoloration. To purchase polishing

liquid, contact your nearby musical instrument dealer.

• Use the polishing liquid only on the polished surfaces of the

cabinet. Always wipe the surface with the grain using straight,

even strokes. Do not repeatedly wipe the same places using too

much pressure, since that might result in the loss of luster.

• Be sure to keep the polishing liquid out of the reach of small

children. If the polishing liquid is accidentally swallowed, first get

them to vomit, then take them to a doctor.

Repairs and Data

• Please be aware that all data contained in the unit’s memory may be

lost when the unit is sent for repairs. Important data should always

be backed up on a USB Memory, or written down on paper (when

possible). During repairs, due care is taken to avoid the loss of data.

However, in certain cases (such as when circuitry related to memory

itself is out of order), we regret that it may not be possible to restore

the data, and Roland assumes no liability concerning such loss of

data.

HP307_e1.book 10 ページ２０１０年１月４日　月曜日　午後５時３９分

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 87 88

Comments to this Manuals

No comments

Roland HP-307 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Musical Instruments Roland HP-307