Roland Stika STX-7 Specifications download pdf (Page 6)

The AC adapter plugs in here

Connect the unit to the Computer

Make sure the two sides of the material are even

Pinch rollers

Parallel connector

Use the clips on either side to

secure the connector in place.

Parallel connector

Use the clips on either side to

secure the connector in place.

Place the material against the pinch rollers.

Load the material as shown in the figure, so that it does not

come loose during cutting.

Loading the material

Do not use any of the following materials. The material may come loose during cutting or otherwise fail to be fed properly.

Materials which has

curled upward

Material with a front edge

that is not straight

Material that is longer than

1 m 10 cm (43-1/4")

Material with left and right

edges that are not parallel

Load the material

Material of the following composition and thickness can be cut.

- Composition Vinyl chloride sheets

- Thickness Sheet portion :0.1 mm (0.00394") or less, including base paper of 0.3 mm (0.0118) or less

The cable is available

separately. Be sure to

use the correct cable for

the computer.

Do not place any objects within the range of material

movement to the front or rear of the unit.

Do not place any object

within the area.

Sheet feed knob

STANDBY key

Blade protector

Pinch rollers

Subrollers

Screw

50 mm

(1-15/16")

Blade carriage

STANDBY LED

Front cover

Parallel Cable

AC adapter jack

1 2 3 4 5 6 7 8 9 10 11 ... 36 37

Comments to this Manuals

No comments

Roland Stika STX-7 Specifications Page 6

Comments to this Manuals

Related products and manuals for Plotter paper Roland Stika STX-7