3
Do not use with any power supply
other than the dedicated AC adapter.
Use with any other power supply may lead
to fire or electrocution.
Install on a stable surface.
Failure to do so
may result in
falling of the unit,
leading to injury.
Installing and Connecting to the Computer
2
Roland Software Package : 1
Blade : 1Blade holder : 1
* The blade holder and blade are installed on
the unit when shipped from the factory.
1
Check the included items
In this manual, the names of the products covered appear as
follows. STIKA PLUS STX-8
STIKA PLUS STX-8 = STX-8
STIKA STX-7 = STX-7
Sections that describe identical procedures for the two models are
indicated as follows.
STX-8/7
The illustrations appearing in this manual depict the STX-8. The STX-7 may differ from the product shown.
Material for test cuts : 1
* Paper : 1 STX-8/7 User's Manual : 1
The configuration of the AC adapter varies according to
regional differences in voltage. Please note that the
descriptions in this manual are for the 117 V adapter.
NOTICE
Never install this unit in any of the following situations, as it could result in damage:
• Places where the installation surface is unstable or not level.
• Places with excessive electrical noise.
• Places with excessive humidity or dust.
• Places with poor ventilation, because the STX-8/7 generates considerable heat during operation.
• Places with excessive vibration.
Use within a temperature range of 5 to 40°C (41 to 104°F) and within a humidity range of 35 to 80%.
Make sure the power to the computer and the STX-8/7 is switched off before attempting to connect the cables.
Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged. Otherwise,
faulty operation or breakdown may result.
How to use this manual
Application tape for test cuts : 1 * Sheet setup guide : 1 * Water based fiber tipped pen : 1
* Included only with the STX-8.
AC adapter : 1
Comments to this Manuals