Roland SOLJET SC-500 User Manual download pdf (Page 22)

Roland CAMMJET and SOLJET Devices

 Applies to: Roland CAMMJET CJ-400/500, CAMMJET PRO II 540, SOLJET SC-

500, SOLJET PRO II SC-540, SOLJET PRO II EX SC-540 EX, SOLJET PRO II

V SC-545 EX

Printing a Laminated Job

If you want to print a job, laminate it, and contour cut it later,

the CAMMJET and SOLJET automatic alignment function

makes it possible to align the printing and cutting positions.

1. Add a setup for the device to PhotoPRINT or Production

Manager.

2. Depending on the application, do the following:

• In PhotoPRINT, add the job and open Job Properties.

• In Flexi, design the job and open the RIP and Print

dialog.

3. Set Send to Print job only.

4. Set Registration mark to Roland SolJet/CAMMJet.

 If you are using PhotoPRINT, the software automatically adds the

appropriate registration marks to the job when you select the output device

in the Workflow tab of Job Properties.

5. Click Send. The print out should look similar to the image

shown below with black circles and crop marks added by

the printer.

6. Remove the media from the printer and laminate it.

7. Reload the media in the printer.

8. Set Send to Contour job only.

9. Click Send and the device will automatically detect the

alignment marks and cut the contour.

Using a CAMMJET or SOLJET as a Virtual Hybrid

To print a job on another device and use a CAMMJET or

SOLJET as a cutter:

1. When printing the job:

a. Select the CAMMJET or SOLJET as the cutter.

b. Set Registration mark to Roland SolJet/CAMMJet.

 If you are using PhotoPRINT, the software automatically adds the

appropriate registration marks to the job when you select the output

device in the Workflow tab of Job Properties.

c. Set Send to Print job only.

2. Print the job. The print out should look similar to the image

below, with black circles and crop marks added by the

printer.

3. Remove the media from the printer.

4. Load the media in the CAMMJET or SOLJET.

5. Set Send to Contour job only.

6. Click Send. The device will automatically detect the

alignment marks and cut the contour.

1 2 ... 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Roland SOLJET SC-500 User Manual Page 22

Comments to this Manuals

Related products and manuals for Print & Scan Roland SOLJET SC-500