Eects
76
AUTO WAH
Cyclically controls a lter to create cyclic change in timbre.
Parameter Value Explanation
Filter Type LPF, BPF
Type of lter
LPF: The wah eect will
be applied over a wide
frequency range.
BPF: The wah eect will
be applied over a narrow
frequency range.
Manual 0–127
Adjusts the center
frequency at which the
eect is applied.
Peak 0–127
Adjusts the amount of the
wah eect that will occur
in the range of the center
frequency.
Set a higher value for Peak
to narrow the range to be
aected.
Polarity UP, DOWN
Sets the direction in which
the frequency will change
when the auto-wah lter
is modulated.
UP: The lter will
change toward a higher
frequency.
DOWN: The lter will
change toward a lower
frequency
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
LO-FI COMPRESS
This is an eect that intentionally degrades the sound
quality for creative purposes.
Parameter Value Explanation
PreFilter TYPE 1–3
Selects the type of lter
applied to the sound
before it passes through
the Lo-Fi eect.
Lo-Fi TYPE 1–9
Degrades the sound
quality. The sound quality
grows poorer as this value
is increased.
Post Filter
Type
OFF, LPF, HPF
Type of lter after it passes
through the Lo-Fi eect
OFF: no lter is used
LPF: cuts the frequency
range above the Cuto
HPF: cuts the frequency
range below the Cuto
Post Filter
Cuto
200–8000 Hz
Basic frequency of the
Post Filter
Gain Low -15–+15 dB Gain of the low range
Gain High -15–+15 dB Gain of the high range
DISTORTION
Intensely distorts the sound. The tone quality of the
distorted sound is adjusted with a lter.
Parameter Value Explanation
Pre HPF
BYPASS,
16–1000 Hz
Frequency of the lter that
cuts the low-frequency
content of the input
sound (BYPASS: no cut)
Drive 0–127 Amount of distortion
Tone 0–127
Tone quality of distorted
sound
OVERDRIVE
Mildly distorts the sound. The tone quality of the
distorted sound is adjusted with a lter.
Parameter Value Explanation
PreHPF
BYPASS,
16–1000 Hz
Frequency of the lter that
cuts the low-frequency
content of the input
sound (BYPASS: no cut)
Drive 0–127 Amount of distortion
Tone 0–127
Tone quality of distorted
sound
ISOLATOR
This is an equalizer which cuts the volume greatly,
allowing you to add a special eect to the sound by
cutting the volume in varying ranges.
Parameter Value Explanation
Boost/Cut Low -64–+63
These boost and cut each
of the low frequency
ranges.
At -64, the sound
becomes inaudible. 0 is
equivalent to the input
level of the sound.
Boost/Cut Mid -64–+63
These boost and cut each
of the middle frequency
ranges.
At -64, the sound
becomes inaudible. 0 is
equivalent to the input
level of the sound.
Boost/Cut High -64–+63
These boost and cut each
of the high frequency
ranges.
At -64, the sound
becomes inaudible. 0 is
equivalent to the input
level of the sound.
Comments to this Manuals