6
Panel descriptions
Control Panel
1. INPUT Jack
Connect your guitar here.
2. SELECT Switch
Switches between the CLEAN and LEAD channels.
You can confirm which channel is selected by checking
the indicator’s color (CLEAN: green; LEAD: red).
3. VOLUME Knob
Adjusts the CLEAN channel volume.
4. LEAD Channel
You can select from the following four types.
OVERDRIVE
Natural distortion sound similar to that obtained by
turning an amp’s volume up completely.
DISTORTION
Harder distortion than OVERDRIVE.
METAL
Even harder and heavier than DISTORTION, which can get
long sustained notes.
METAL STACK
Very fat sound of a Heavy Metal full amp stack.
5. GAIN Knob
Adjusts the LEAD channel’s distortion level.
6. VOLUME Knob
Adjusts the LEAD channel volume.
7. BASS Knob
Adjusts the tone quality of the lower range.
8. MIDDLE Knob
Adjusts the tone quality of the midrange.
9. TREBLE Knob
Adjusts the tone quality of the upper range.
* No sound will be produced when BASS, MIDDLE, and
TREBLE knob are all set to 0.
10.
AUX IN Jack
You can connect a CD player, MP3 player or other kind
of device and have it play along with your guitar.
This accepts a stereo miniature phone plug. However, the
speaker and RECORDING OUT/PHONES output is monaural.
* Determine the volume level by adjusting the volume control of
the connected device.
* The Power Squeezer function is also applied to sounds input
from the AUX IN jack.
11.
RECORDING OUT/PHONES Jack
When Using RECORDING OUT
Use mono 1/4” phone plugs when
connecting to this jack.
Volume level of RECORDING OUT can be
easily adjusted if you set the CLEAN or LEAD
Channel VOLUME knob as shown in the
diagram on the right.
When Using Headphones
Connect headphones to this jack.
* No sound is played through the unit’s speaker while the
RECORDING OUT/PHONES jack is in use.
12.
POWER SQUEEZER Switch
Switching on the Power Squeezer function allows you to
reduce the amp’s output to 2 watts.
Switching this on allows you to produce a sound that
preserves the same tone and balance as when the amp is
played at maximum volume, but at an output of 2 watts, for
volume levels that are more suitable for the average home.
13
.POWER Switch
This switches the power on and off.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 5).
1
2 6
7
8
4
3
9
10 11
5
12
13
CLEAN Channel
LEAD Channel
EQUALIZER
CUBE-15X_e.book 6 ページ ２００６年８月７日 月曜日 午後１２時０分
(8 pages)
(80 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals