Roland VK-7 Owner's Manual download pdf (Page 19)

Before You Begin Playing

Turning the Power On

Before turning on the VK-8’s power, make sure that:

• The VK-8 is correctly connected to the desired peripheral devices.

• The volume of the VK-8 and any connected audio equipment or

speakers is turned to the minimum position.

Press the upper portion of the [POWER] switch located on the rear panel

of the VK-8 to turn on the power.

When the power is on, the indicators for the HARMONIC BAR PART [UPPER]

button, [REVERB] button, and other buttons on the panel will light.

fig.01-07

Turn on the power of the connected amp or audio system.

Rotate the [MASTER VOLUME] knob clockwise to adjust the volume of

the VK-8.

fig.01-08

Adjust the volume of the device connected to the VK-8.

■

Turning Off the Power

Before switching off the power, confirm the following:

• The volume of the VK-8 and any connected equipment is turned to the

minimum position.

• Any sound data you have created has been saved.

Turn off the power of the equipment connected to the VK-8.

Press the lower portion of the VK-8’s [POWER] switch to turn off the

power.

fig.01-07

NOTE

Once the connections have

een completed, turn on

power to your various devices

in the order specified. By

turning on devices in the

wrong order, you risk causing

malfunction and/or damage to

speakers and other devices.

NOTE

This unit is equipped with a

protection circuit. A brief

interval (a few seconds) after

power up is required before

the unit will operate normally.

NOTE

If you need to turn off the

power completely, first turn

off the POWER switch, then

unplug the power cord from

the power outlet. Refer to

“Power Supply” (p. 5).

NOTE

Be careful not to raise the

volume excessively. Excessive

volume may damage your

amp/speaker system/

headphones or could cause

hearing problems.

NOTE

If you turn off the power while

you are making sound

settings, the settings that you

are modifying will be lost. If

you wish to keep your

modified settings, you must

save them before turning off

the power. For details, refer to

“Saving Your Settings

(Preset)” (p. 45).

NOTE

If you need to turn off the

power completely, first turn

off the [POWER] switch, then

unplug the power cord from

the power outlet. Refer to

“Power Supply” (p. 5).

VK-8_e.book 19 ページ２００５年７月２５日　月曜日　午後４時２４分

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Comments to this Manuals

No comments

Roland VK-7 Owner's Manual Page 19

Comments to this Manuals

Related products and manuals for Mixers Roland VK-7