Roland JUNO-Di User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 136
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
20
Getting Ready
941
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/
or damage to speakers and other devices.
1.
Before turning on the JUNO-Di’s power, consider these
two questions:
Is the AC adaptor and any other equipment connected correctly?
Have the volume controls of the JUNO-Di and all connected audio
devices been turned to their lowest settings?
2.
Turn on the [POWER] switch located on the rear panel of
the JUNO-Di.
fig.power-onoff.eps
Always make sure to have the volume level turned down
before switching on power. Even with the volume all the way
down, you may still hear some sound when the power is
switched on, but this is normal, and does not indicate a
malfunction.
To ensure proper operation of the pitch bend lever, make sure
not to touch the lever when turning the JUNO-Di’s power on.
fig.Bender2-e.eps
3.
Turn on the power for any connected audio devices.
4.
While playing the keyboard and listening to the sound,
slowly increase the volume of the JUNO-Di and the
volume of the connected equipment until you obtain the
desired volume.
fig.volume1.eps
1.
Before turning off the power, consider these two
questions:
Have the volume controls of the JUNO-Di and all connected audio
devices been turned to their lowest settings?
Have you saved your JUNO-Di sounds or other data you’ve created?
2.
Turn off the power for all connected audio devices.
3.
Turn off the [POWER] switch of the JUNO-Di.
fig.power-onoff.eps
1.
Use the [VOLUME] knob to adjust the volume.
Turning the knob toward the left will decrease the volume, and
turning it toward the right will increase the volume.
Also adjust the connected device to an appropriate volume.
fig.volume2.eps
The characters in the display may be difficult to read immediately after
the power is turned on, or after you have been using the JUNO-Di for an
extended time, or due to the conditions in which it’s being used. If this
occurs, turn the rear panel [LCD CONTRAST] knob to make the display
legible.
fig.LCDcontrast.eps
Turning On/Off the Power
On
Lower position
Turning Off the Power
Adjusting the Volume Level
([VOLUME] Knob)
Adjusting the Display Contrast
([LCD CONTRAST] Knob)
Off
Upper position
JUNO-Di_e.book 20 ページ 2009年6月22日 月曜日 午前9時23分
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 135 136

Comments to this Manuals

No comments