Roland SJ-540 User Manual download pdf (Page 18)

2. Using the Heater Unit

Switching On the Controller

Switch on the [POWER] switch on the controller.

After the display flashes for a short time, both [SV] and

[PV] light up and indicate their values. If only [SV]

flashes, go to step 2.

Switch on the sub power for the printer.

[SV] lights up and the heater is ready to operate.

The [C1] indicator on the display lights up.

The heater starts operating.

Switching Off the Controller

Switch off the [POWER] switch on the controller.

Power Source for the Heater

The heater is connected to the sub power for the printer.

The heater operates only when both the controller and the sub power for printer are switched on.

When the display shows characters other than numerical figures, such as UUUU or LLLL, immediately switch off the control-

ler and contact your authorized Roland DG Corp. dealer or service center.

Switch off the controller when not using the heater.

The preset temperature of the heater is saved in memory when the controller is switched off.

2-1 Switching the Power On and Off

When not in use for extended periods, unplug the power-cord plug from the electrical outlet.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Roland SJ-540 User Manual Page 18