Roland RD-700 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 172
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16
Getting Ready
Getting Ready
Installing SRX Series Boards
1
Before installing any Wave Expansion Board, turn off the
power on the RD-700 and all devices connected to it.
2
Refer to the following illustration of the RD-700’s rear panel,
and remove the screws indicated. Then, remove the cover.
fig.Q-02.e
3
Insert the Wave Expansion Board connector into a connector
for an SRX Series slot (SRX A or SRX B), while simultaneously
inserting the board holders into the holes in the Wave
Expansion Board.
fig.Q-05.e
Screws to be removed
Wave Expansion Board (SRX series)
Board holder
Position them as shown
before you install the board.
Connector
NOTE
If the same type of Wave
Expansion Board is
installed in the SRX A slot
and the SRX B slot, it will
only be possible to select
data from the Wave
Expansion Board that was
installed in the SRX A slot.
RD-700_e.book 16 ページ 2004年4月26日 月曜日 午前11時54分
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 171 172

Comments to this Manuals

No comments