Roland VS-1680 User Manual download pdf (Page 117)

Sens (De-esser Sensitivity)

Adjust the degree to which the de-esser effect will

affect the input signal.

Freq (De-esser Frequency)

Adjust the frequency at which the de-esser effect will

apply. The effect will apply to frequencies above the

specified value.

Lmt (Compressor/Limiter)

Depending on the setting of the parameters, this effect

can be used as a compressor or as a limiter. A com-

pressor holds down high-level signals and boosts low-

level signals, evening out the volume. A limiter is used

when you wish to hold down excessive input levels.

Sw (Switch)

Turn the Compressor/Limiter on/off.

Thrsh (Threshold)

Adjust the level at which the effect will begin to apply.

To use this effect as a limiter, set a high Threshold

Level.

Ratio

Select the compression ratio that will apply when the

Threshold Level is exceeded. When using the effect as

a limiter, you will normally set this to “100:1.”

Attack (Attack Time)

Adjust the time from when the input level exceeds the

threshold level to when the effect begins to apply.

When using the effect as a limiter, set a short Attack

Time.

Release

Adjust the time from when the input level drops

below the threshold level to when the effect ceases to

apply. When using the effect as a limiter, set a short

Release Time.

Level

Adjust the output level.

Detect HPF Freq (Frequency)

Adjust the cutoff frequency of the level detection sec-

tion. With a setting of Thru, this will operate as a con-

ventional limiter.

Detect (Detector in)

This is used to select the input source which INPUT A

or INPUT B that is to be used for controlling the effect.

Set it to “Link” if you want the unit to detect which

input source is of a higher level and automatically use

that source for control.

Enh (Enhancer)

The enhancer is an effect that adds phase-shifted

sound to the direct sound, sharpening the focus of the

sound and bringing it to the front of the mix.

Sw (Switch)

Turn the Enhancer on/off.

Sens (Sensitivity)

Adjust the degree of the enhancer effect relative to the

input volume.

Freq (Frequency)

Adjust the frequency at which the effect will begin to

apply. The effect will apply to frequencies above the

specified value.

MixLvl (Mix Level)

Adjust the amount of the phase-shifted sound that is

mixed into the input.

Level

Adjust the level of the effect sound.

Rot (Rotary)

Rotary is an effect that simulates a rotary speaker. This

produces the characteristic sound of two rotating

speakers (a high rotor and a low rotor).

LRate (Low Rate)

Adjust the rotating rate of the low-range rotor.

HRate (High Rate)

Adjust the rotating rate of the high-range rotor.

Function of Each Effect Parameter

117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 135 136

Comments to this Manuals

No comments

Roland VS-1680 User Manual Page 117

Comments to this Manuals

Related products and manuals for Musical Instruments Roland VS-1680