Roland JX-10 Owner's Manual download pdf (Page 21)

to edit. If the dot is seen at the corner of the other Tone number, simply push the Upper or Lower Button which is

relevant.

If any of the switches or buttons on the programmer is even slightly moved, the Tone number in the Display

flashes. This flashing always means that the Tone is edited, therefore different from the one in memory.

To see the name or the value of the parameter which you are now editing, do as follows:

1. Push the TONE of the Edit Buttons. The Display will respond with:

2. Edit with the PG-800.

The parameter name and its value are shown in the Display.

MANUAL MODE

The JX-10 features Manual mode in which the whole panel setting of the programmer decides the Tone. That is,

now existing Tone written in memory has nothing to do with your sound synthesis. To turn the JX-10 to this mode,

simply push the Manual Button on the PG-800.

• If there is no change by moving the knob or switch on the programmer, it is because the position you have set

is exactly the same as the preprogrammed. If it happens, just ignore it and move to the next procedure.

• It may be quicker and easier to select a Tone that is similar to the one you want to synthesize, then modify it.

2. Editing without using the Programmer

The parameters of a Tone have two figure numbers. To edit a Tone without using the programmer, call each

parameter by assigning the appropriate number and change the value with the α Dial.

1. Press Tone button

2. Press Parameter button

a. If necessary press Upper or Lower button to select the Tone that must be edited

i. Pressing Upper or Lower button again, the display will show:

Where I = internal – XX = Patch number

3. Select the parameter to edit with α Dial

4. Press Value button

5. Change the value with the α Dial

Alternatively, to scroll back and forth the parameters 11 DCO RANG ~ 95 ENV2 KEY use

Then press Value button and change the value with the α Dial

I –xx ******* Recall *******

Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM

Pag. 21 of 53

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 52 53

No comments

Roland JX-10 Owner's Manual Page 21