Roland TD-7K Owner's Manual download pdf (Page 66)

Troubleshooting / Error Messages

Could you be using a connection cable that contains

a resistor?

Use a connection cable that does not contain a resistor.

Check the volume level of the connected audio source.

See the owner’s manual for the device if there’s a problem.

No Ambience Applied

Is the Ambience set to “OFF?” (p. 26)

Press [AMBIENCE], then switch the setting to “ON.”

Pad Not Playing Correctly

Is the trigger type setting correct?

Set the trigger type (p. 50).

Is the pad’s sensitivity setting correct?

Set the pad sensitivity (p. 40, p. 52).

* For fullest expression in performance, we recommend the

exclusive use of Roland pads.

Is the KD-80, KD-120, PD-80, PD-80R, PD-100, PD-

105, PD-120, or PD-125 head tightened uniformly?

Refer to the owner’s manual for the pad you are using, then

adjust the head tension. This is very important for proper

triggering.

Wrong Sound Plays

Is there a mistake in the head and rim selection? (p.

24)

As you can make separate settings for the head and rim,

confirm the trigger input, then adjust.

Are you playing the rim shot (p. 19, p. 46) and cross

stick (p. 20, p. 46) correctly?

To play rim shots, strike the head and rim simultaneously. For

cross stick, be sure your hand or stick does not touch the head.

Sound in Headphones Distorted

Sometimes, setting the output too high certain tones

can the sound seem distorted.

Turn down the VOLUME. Or check your headphones.

Output Sound Is Distorted

Check your input levels on your mixer or amp.

Check individual level and pan positions.

Press [LEVEL/PAN] to display the instrument level, then

press [-] to lower the level for the pad instrument.

You can suppress distortion by setting the pan near the center.

Press [LEVEL/PAN] to display the instrument’s pan setting,

then press [+] or [-] to adjust the setting.

Is the MIDI connection/cable correct? (p. 62)

If you wish to save a bulk dump on an external device,

connect the TD-3’s MIDI OUT connector to the external

sequencer’s MIDI IN connector.

Is the external MIDI device set to NOT receive MIDI

Exclusive messages?

Refer to the owner’s manual for the external MIDI device, then

set it so that the reception of System Exclusive data is enabled.

* System Exclusive data is a kind of data used only by a

particular device; bulk dump data is one type of System

Exclusive data.

No Sound/Low Volume from Source

Connected to the MIX IN Jack

Drum Kit Does Not Sound As

Intended

Pad Does Not Sound As Intended

Sound is Distorted

Cannot Carry Out Bulk Dump

TD-3_e.book 66 ページ２００４年５月１７日　月曜日　午前１０時６分

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Comments to this Manuals

No comments

Roland TD-7K Owner's Manual Page 66

Comments to this Manuals

Related products and manuals for Music drums Roland TD-7K