Roland FC-300 Owner's Manual download pdf (Page 21)

Control Change Mode

This is the mode for sending Control Change messages.

In this mode, all the pedals can be used to send Control Change messages. You

should use this mode at times when you want to send a lot of Control Change

messages.

You can also store up to five sets, or configurations, of settings for all of the pedals

within the FC-300’s memory. Called pedal settings, these configurations can be

switched as needed (p. 26).

Pressing the various pedals transmits the Control Change messages set for the

respective pedal over the selected MIDI channel.

Control Change messages with the controller numbers set for each pedal are

transmitted.

Each pedal is set at the factory as shown below.

These switch the number pedal functions.

About the Control Change Mode

Transmitting Control Change Messages

Number Pedal (1/6–5/10)

Pedal

CC# Range Mode Pedal CC# Range Mode

65 0–127 LATCH 6 70 0–127 LATCH

2 66 0–127 LATCH 7 71 0–127 LATCH

3 67 0–127 LATCH 8 72 0–127 LATCH

4 68 0–127 LATCH 9 73 0–127 LATCH

5 69 0–127 LATCH 10 74 0–127 LATCH

[ ] [ ] Pedal

Pedal

Explanation

[]

This sets the number pedals to function as pedals 1–5.

[] This sets the number pedals to function as pedals 6–10.

Pedal Setting Number

For details about the all

parameters and changes the

setting, refer to “Change the

Pedal Settings” (p. 24).

When the [ ] pedal is pressed, the [ ] pedal’s indicator lights, and the functions

for number pedals 1–5 become operable.

When the [ ] pedal is pressed, the [ ] pedal’s indicator lights, and the functions

for number pedals 6–10 become operable.

FC-300_e2.book 21 ページ２００７年１０月４日　木曜日　午後５時２２分

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

No comments

Roland FC-300 Owner's Manual Page 21