Roland FC-300 Owner's Manual download pdf (Page 50)

Other Features

Change this parameter if the indicator on an amp connected to an AMP CONTROL

jack (1 or 2) does not correspond to the ON indicator (indicator lit) on the FC-300.

Press PARAMETER [ ] [ ] to select “SYS:AMP 1 Pol.” or

“SYS:AMP 2 Pol.”

Press VALUE [ ] [ ] to make the setting.

When you’ve finished making the settings, press [UTILITY] or [EXIT].

Follow the steps below to specify whether a pedal being connected to an EXP

PEDAL/CTL jack (on the rear panel) is a control pedal or an expression pedal. This

setting needs to be made individually for each jack.

Press PARAMETER [ ] [ ] to select “SYS:E3/C3 Type”, “SYS:E4/C5 Type”

or “SYS:E5/C7 Type.”

Press VALUE [ ] [ ] to make the setting.

When you’ve finished making the settings, press [UTILITY] or [EXIT].

Setting the Polarity of the AMP CONTROL Jacks

Value

Explanation

NORMAL

The parameter is set to the factory setting.

INVERT Actual operation is the reverse of that indicated by the FC-300’s ON/OFF

indicator.

Determining the Role of an EXP PEDAL/CTL Jack

Value

Explanation

EXP PEDAL

The jack will be used for connecting expression pedals.

Connect a Roland EV-5 or BOSS FV-500L or FV-500H.

CTL The jack will be used for connecting control pedals.

Connect a BOSS FS-5U or FS-6.

FC-300_e2.book 50 ページ２００７年１０月４日　木曜日　午後５時２２分

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

No comments

Roland FC-300 Owner's Manual Page 50