Roland FP-2 Owner's Manual download pdf (Page 31)

Chapter 2 Playing Along with Rhythms

Performing With the Chord Progression

Specified in the Left Hand

(Chord Progression off)

Performing with the keyboard divided at a certain key into a left side and a

right side is called “Split Play.”

While in Split Play, you can use the left side to specify chords instead of

using it to play the Lower Tone.

fig.02-13

Press the [Chord Progression] button, getting its indicator to

go out.

The [Split] button’s indicator lights up.

The indicator for the [Start/Stop] button flashes in red, and the FP-2 is put

into standby mode.

The chord is specified with a key in the left part of the

keyboard, and the Rhythm begins.

fig.02-14

Specify the chord in the left part of the keyboard, and perform the melody

in the right side.

It is not necessary to continue holding down the keys for chords in the left

side. Even after you release the key, the same chord continues until the next

chord is played.

When specifying chords, sounds from the left side of the keyboard are not

played.

To stop the Rhythm, press the [Start/Stop] button.

After the ending is done, the performance stops.

The indicator for the [Start/Stop] buttons then start flashing in red, and the

FP-2 is put into standby mode.

To exit, press the [Chord Progression] button.

NOTE

When specifying the

chords in the left part of the

keyboard, Dual Play (p. 15)

is disabled in the right part.

1,43

You can specify chords

simply with your finger,

even without playing the

keys for all the chords’

constituent notes. For more

information about chord

fingering, refer to the

“Chord Fingering List” (p.

62).

F 3 (Split point)

The range specified a chord

The button’s indicator does

not go out when you press

the [Split] button here. At

this point, you can perform

with the Lower Tone while

specifying chords in the left

part of the keyboard.When

you press the [Split] button

once more, the button’s

indicator does go out, and

you can perform while

specifying chords over the

entire keyboard.

The point at which the

keyboard is divided is

called the “split point”; you

can also change this split

point. For more

information, take a look at

“Changing the Keyboard’s

Split Point” (p. 18).

FP-2_e.book 31 ページ２００４年１１月２６日　金曜日　午後４時２５分

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 75 76

Comments to this Manuals

No comments

Roland FP-2 Owner's Manual Page 31

Comments to this Manuals

Related products and manuals for Musical Instruments Roland FP-2