Roland FP-2 Owner's Manual download pdf (Page 4)

IMPORTANT NOTES

291a

In addition to the items listed under “USING THE UNIT SAFELY” on page 2 and 3, please read and observe the following:

Power Supply

301

• Do not connect this unit to same electrical outlet that is

being used by an electrical appliance that is controlled by

an inverter (such as a refrigerator, washing machine,

microwave oven, or air conditioner), or that contains a

motor. Depending on the way in which the electrical

appliance is used, power supply noise may cause this unit

to malfunction or may produce audible noise. If it is not

practical to use a separate electrical outlet, connect a

power supply noise filter between this unit and the

electrical outlet.

302

• The AC adaptor will begin to generate heat after long

hours of consecutive use. This is normal, and is not a

cause for concern.

307

• Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

Placement

351

• Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum.

To alleviate the problem, change the orientation of this

unit; or move it farther away from the source of inter-

ference.

352a

• This device may interfere with radio and television

reception. Do not use this device in the vicinity of such

receivers.

352b

• Noise may be produced if wireless communications

devices, such as cell phones, are operated in the vicinity of

this unit. Such noise could occur when receiving or initi-

ating a call, or while conversing. Should you experience

such problems, you should relocate such wireless devices

so they are at a greater distance from this unit, or switch

them off.

354a

• Do not expose the unit to direct sunlight, place it near

devices that radiate heat, leave it inside an enclosed

vehicle, or otherwise subject it to temperature extremes.

Excessive heat can deform or discolor the unit.

355b

• When moved from one location to another where the

temperature and/or humidity is very different, water

droplets (condensation) may form inside the unit. Damage

or malfunction may result if you attempt to use the unit in

this condition. Therefore, before using the unit, you must

allow it to stand for several hours, until the condensation

has completely evaporated.

358

• Do not allow objects to remain on top of the keyboard.

This can be the cause of malfunction, such as keys ceasing

to produce sound.

Maintenance

401a

• For everyday cleaning wipe the unit with a soft, dry cloth

or one that has been slightly dampened with water. To

remove stubborn dirt, use a cloth impregnated with a

mild, non-abrasive detergent. Afterwards, be sure to wipe

the unit thoroughly with a soft, dry cloth.

402

• Never use benzine, thinners, alcohol or solvents of any

kind, to avoid the possibility of discoloration and/or

deformation.

Additional Precautions

552

• Unfortunately, it may be impossible to restore the contents

of data that was stored in another MIDI device (e.g., a

sequencer) once it has been lost. Roland Corporation

assumes no liability concerning such loss of data.

553

• Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its jacks

and connectors. Rough handling can lead to malfunctions.

556

• When connecting / disconnecting all cables, grasp the

connector itself—never pull on the cable. This way you

will avoid causing shorts, or damage to the cable’s

internal elements.

558a

• To avoid disturbing your neighbors, try to keep the unit’s

volume at reasonable levels. You may prefer to use

headphones, so you do not need to be concerned about

those around you (especially when it is late at night).

559a

• When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise,

you will need to use equivalent packaging materials.

560

• Do not apply undue force to the music stand while it is in

use.

561

• Use only the specified expression pedal (EV-5; sold

separately). By connecting any other expression pedals,

you risk causing malfunction and/or damage to the unit.

562

• Use a cable from Roland to make the connection. If using

some other make of connection cable, please note the

following precautions.

• Some connection cables contain resistors. Do not use

cables that incorporate resistors for connecting to this

unit. The use of such cables can cause the sound level

to be extremely low, or impossible to hear. For infor-

mation on cable specifications, contact the manufac-

turer of the cable.

Handling CD-ROMs

801

• Avoid touching or scratching the shiny underside

(encoded surface) of the disc. Damaged or dirty CD-ROM

discs may not be read properly. Keep your discs clean

using a commercially available CD cleaner.

FP-2_e.book 4 ページ２００４年１１月２６日　金曜日　午後４時２５分

1 2 3 4 5 6 7 8 9 ... 75 76

Comments to this Manuals

No comments

Roland FP-2 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Musical Instruments Roland FP-2