Roland CX-400 Specifications download pdf (Page 58)

Er1:Command

Not Recognized

Er2:Wrong Number

of Parameters

Er3:Out of

Parameter range

Er5:Unknown

Character Set

9-3 Error Messages

An error message will appear if incoming data has any of the errors listed in table. Since the error is shown in the display for

informational purposes, the data transfer continues and you are allowed to perform the next operation.

To clear the display, press any key.

If an error occurs, correct cutting may become impossible.

The error messages that may appear on the display are described below.

In almost all cases, the cause is receiving incorrect data. For information about corrective action, go to “9-2 What to Do If...” and

refer to “CX-500/400/300 Troubleshooting.”

Error massage Meaning

Appears if an instruction that the CX-500/400/300 cannot interpret is sent. Additionally,

this error is generated if an instruction from the “mode2” set is sent when the unit has

been set to recognize “mode1,” or vice versa. Change the setting for the recognized

instruction set, using the display menu, and this error should no longer occur.

Appears if the number of parameters differs from the permissible number.

Appears if the value specified for a parameter is out of the permissible range.

Appears if an unusable character is specified.

1 ... 57 58 59 60 61 62 63 64

No comments

Roland CX-400 Specifications Page 58