Roland R-44 Specifications download pdf (Page 10)

Introducing the R-44

Phantom Power Switches [PHANTOM POWER]

These switches turn the phantom power on/off for the XLR connectors of the combo input jacks located on

the right panel. You can turn phantom power on/off separately for channels 1/2/3/4 because they have

separate switches.

*Always turn the phantom power off when connecting any device other than

condenser microphones that require phantom power. You risk causing damage

if you mistakenly supply phantom power to dynamic microphones, audio

playback devices, or other devices that do not require such power. Be sure to

check the specifications of any microphone you intend to use by referring to the

manual that came with it.

This instrument’s phantom power: 48 V DC, 8 mA Max (total of all channels must be 20 mA or less)

Hold Switch [HOLD]

By selecting the HOLD ON position, you can disable the panel buttons so that unwanted operations will not

occur if a button is pressed accidentally.

However, even if this switch is set to HOLD ON, the Phantom power switches , Low cut switch

, Limiter switch , Input level knobs , and Monitor level knob will still be operable.

Low Cut Switch [LOW CUT]

Turing this switch on allows you to record while cutting the lower range portion of the input signal. Turn

it on when breath noise (breathing sounds during voice recording) or wind noise (when recording outside)

may be a problem.

Limiter Switch [LIMITER]

This switch turns the input level limiter on/off.

The limiter compresses the input level appropriately to prevent distortion when the input level is too high.

The limiter can be set to work with respect to each channel independently or for a combination of channels

(linked). For details, refer to “Limiter link” (p. 68).

5 6

8 9

14 15 16

XLR plug

TRS phone

plug

(balanced)

Phone plu

(unbalanced

)

4AGAPGYDQQMࡍ࡯ࠫ㧞㧜㧜㧤ᐕ㧡᦬㧝㧡ᣣޓᧁᦐᣣޓඦᓟ㧠ᤨ㧡㧟ಽ

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

No comments

Roland R-44 Specifications Page 10