Roland CJ-540 User Manual download pdf (Page 48)

Chapter 2 - Basic Operation

2-3 Loading Media

Separating the Media

Make sure the [SETUP] LED lights up.

To cut off a printed portion from the roll, hold down the [SHEET CUT] key for at least one second. The piece is cut off

at the present location of the printing-start line. This step is not necessary when cutoff is performed automatically by

sending a media-cutoff command from the computer.

Removing the Media

Refer to the previous section, "Separating the

Media," and cut off the media.

When the SETUP LED is lighted, hold down

the [SETUP] key for at least one second.

Move the sheet loading lever toward the back

of the unit.

The pinch rollers rise to release the media.

Remove the media.

Depending on the composition of the media, cutoff may

not be possible.

Depending on the composition of the media, media may

remain on the platen after cutoff. If this happens, remove

it by hand.

When you're performing cutoff, do not use the [

] key

to pull the media back. Unless the end of the media has

been pulled out to a location to the front of the platen,

cutoff may not be performed smoothly.

The SETUP LED goes out

Sheet loading lever

Knife guide

Printed portion

The media is

cut off here.

Present location

of the blade tip

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 123 124

No comments

Roland CJ-540 User Manual Page 48