Roland XC-540MT User Manual download pdf (Page 54)

Chapter 3 Using the Cutting Feature

3-2 Performing Printing Followed Immediately by Cutting

Performing Printing Followed Immediately by Cutting

You can perform printing and cutting at the same time. When you send data that contains information

for both printing and cutting, then after the printing has nished, the cutting operation starts.

Important

Set [AUTO ENV. MATCH] to "ENABLE"

 P.92, "Making the Setting for Automatic Adjustment of the Printer to the Operating Environment "

Before you start cutting, allow the media to dry thoroughly. If the media is not dry enough, the

pinch rollers or the blade may smudge the printed surface during cutting. Drying time may vary

according to the type of media or the settings of the media heating system.

Use your software RIP to make the setting for the drying time. For information on how to make

the setting, refer to the documentation for the software RIP you're using.

 P.38 "Settings for the Media Heating System"

If the lines for printing and for cutting do not match up, alignment for printing and cutting is re-

quired.

 P.117"Correcting Misalignment of the Printing and Cutting Positions During Printing Followed Immediately

by Cutting"

Depending on the type of media and the temperature of the media heating system, expansion or

contraction of the media may cause the positions for printing and cutting to become misaligned.

If this happens, use the cropmark feature to perform alignment for printing and cutting automati-

cally.

 P.53"Cutting Using the Crop-mark Feature"

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 171 172

No comments

Roland XC-540MT User Manual Page 54