Roland ADA-7000 Owner's Manual download pdf (Page 17)

Supplementary Notes

If the system software of the VM-C7200/C7100

is version 1.10 or later;

If the system software of the VM-C7200/C7100 is version 1.10 or later, following functions are supported.

Clock source setting

You can set up the ADA-7000’s clock source with the

VM-C7200/C7100 console.

1. Hold down [SHIFT], and press [PROJECT]. SYSTEM menu appears in the display.

2. Select “SYSTEM CONFIG” and go to “R-BUS 1(/2/3)” page.

3. Following page appears in the display.

fig.ada_70

* If the above menu does not appear in the “R-BUS 1(/2/3)” page of “SYSTEM CONFIG” menu, please turn off the

power of whole system, check the R-BUS connection and turn on again.

4. Select a desired source with [V1 (CLOCK SOURCE)] knob.

5. Press [F1 (SET)] and the clock source you selected is activated.

6. If you select “INTERNAL” for the clock source, set the sampling rate with [V3 (SAMPLING RATE)] knob.

7. Press [F3 (SET)] and the sampling rate you selected is activated.

FRONT PANEL CONTROL

In the R-BUS 1(/2/3) page, you can prohibit the ADA-7000’s panel operation.

1. Hold down [SHIFT], and press [PROJECT]. SYSTEM menu appears in the display.

2. Select “SYSTEM CONFIG” and go to “R-BUS 1(/2/3)” page.

3. Press [F5 (FRONT PANEL CONTROL)].

Highlight ON: Panel control enabled

Normal ON: Panel control invalid

Remote control of the gain and phantom power

You can control the gain setting and phantom power on/off with the VM-C7200/C7100 console.

1. Press [MULTI IN 1-24] in the “SECTION” block.

2. Press [PREAMP GAIN] in the “PARAM VIEW on Fader” block.

3. Control the gain and phantom power on/off in the same manner as for the [INPUT].

* PAD on the ADA-7000 is automatically switched on/off according to the gain setting.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Roland ADA-7000 Owner's Manual Page 17