Roland ep-5 Service Manual download pdf (Page 6)

– 6 –

Storage Seal

P5/EP5 is supplied with all enclosure entry

points sealed.The seal is only a storage seal, not

to be used as seal when P5/EP5 is in operation.

If Storage Seal is removed or damaged, make

sure all open enclosure entry points are proper

resealed before further shipping or storage.

Use circular stickers marked I, S and OUT,

supplied on Storage Seal or vapour proof tape.

Remove Storage Seal from connection block,

mount positioner on actuator/valve, make

connections according to section 5, (Page 9).

Calibrate span and Zero according to section 7,

(Page 11).

Clean any oil/debris off the connecting block,

then reseal open enclosure entry ports, use

circular stickers marked I, S and OUT, supplied

on Storage Seal or vapour proof tape.

EP5

Follow P5 instructions as above. Remove

Storage Seal for conduit entry I

connect input

signal cable and install proper cable gland to

secure the units sealing.

IP5-SEAL

P5-SEAL

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

No comments

Roland ep-5 Service Manual Page 6