Roland PC-50 User Manual download pdf (Page 10)

5-4 Installing a Ribbon Cartridge

NOTICE

• A used ribbon cartridge cannot be reused. Do not attempt to turn over and reinstall a used ribbon cartridge, or to rewind the ink

ribbon and reuse the cartridge.

• If a single-color ink ribbon has been used for printing, do not attempt to print overtop of this with a four-color ink ribbon or an ink

ribbon of a different color.

• Before starting to print, make sure that a ribbon cartridge of the desired color has been installed.

• If only cutting is to be performed, there is no need to install a ribbon cartridge.

Remove Excess Slack from the Ink Ribbon

The ink ribbon may show some slack when the stopper

has been removed from the ribbon cartridge. If this is the

case, the slack should be taken up before the ribbon

cartridge is installed.

Use your finger or a

pen to take up excess

slack in the ink ribbon.

Take care to ensure that the ink ribbon

does not catch on the printing head.

2)Install the ribbon

cartridge.

Ink ribbon

Remove the stopper

3) Close the

cover.

Take care to ensure

that the ink ribbon is

not pinched when the

cover is closed.

1) Open the

cover.

Printing head

5 Basic Operation

If the ink ribbon runs out while printing

1) If the ink ribbon runs out during printing, operation stops.

The PAUSE LED and CHANGE LED will blink simultaneously.

2) Remove the old ribbon cartridge.

3) Install a new ribbon cartridge, then press the CHANGE key. (Be sure to install an ink ribbon of the same type as the old one.)

Process Color Printing

Full-color printing is performed using the process colors CYAN (C), MAGENTA (M), YELLOW (Y), and BLACK (K).

The method used for printing depends on the type of cartridges that are installed.

How to Perform Printing

If data is sent to the machine while a single-color ribbon cartridge is installed, the carriage specifies "SPECIAL COLOR" and stops.

When this happens, replace the cartridge to CR-4C and press the CHANGE key.

When using a CR-4C ribbon cartridge

All four CMYK colors are contained in a single ribbon cartridge, so there is no need to change cartridges during printing.

The cartridge contains successive lengths of ribbon of each color.

When using CR-CY, MG, YE, and BK ribbon cartridges

During printing, the single-color ribbon cartridges are manually changed according to the color required. This method is more

economical than using the CR-4C, because no portions for ink ribbons are wasted. CR-CY, MG, YE, and BK ribbon cartridges are

sold separately.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Comments to this Manuals

No comments

Roland PC-50 User Manual Page 10

Comments to this Manuals

Related products and manuals for Digital pianos Roland PC-50