Roland PC-50 User Manual download pdf (Page 18)

9 About the Blade

If the blade becomes dull

When the blade starts to lose its sharpness, try gradually increasing the cutter force.

Increasing the cutter force temporarily allows the blade to perform better. However, once the blade is dull, it is time to replace it.

Average blade life

The life of a blade varies, depending on the amount of cutting it performs.

The total cutting length can vary considerably, depending on the thickness, toughness, and type of adhesive of the cut material. Set an

appropriate cutter force, one that is well matched to the material and the hardness of the blade. This will extend the life of the blade.

Excessive cutter forces can cause the blade to wear out quickly. Care should be taken.

8 About the Printing/Cutting Area

Factory default

When DIP switch SW-6 (cut

sheet mode) is ON (enabled)

12.5

(1/2")

12.5

(1/2")

25 mm (1")

110 mm (4-3/8")

or more

When DIP switch SW-5 (front

edge sense) is ON (enabled)

12.5

(1/2")

..... Printing/Cutting area

50 mm (2")

25 mm (1") or more

25 mm (1")

6.5 mm

(5/16")

6.5 mm

(5/16")

6.5 mm

(5/16")

Pinch roller (left)Pinch roller (left)

Pinch roller

(left)

Printing with a width of 210 mm or more (using a 4-color ribbon cartridge)

Take steps to ensure that the

printing data does not overlap

with the ink-ribbon seam

Ink-ribbon seam

No good

210 mm (8-1/4") (length of the ink ribbon)

7 Printing and Cutting Samples / 8 About the

Printing/Cutting Area / 9 About the Blade

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Roland PC-50 User Manual Page 18

Comments to this Manuals

Related products and manuals for Digital pianos Roland PC-50