Roland PC-50 User Manual download pdf (Page 15)

5 Basic Operation

5-10 Performing a Self-test

The PC-50 is equipped with a “self-test” function to allow you to check whether or not it is capable of operating normally. If the PC-50 is

not performing correctly, follow the steps below to perform a self-test.

A computer is not required in order to carry out the self-test.

5-11 Powering Off

NOTICE

• Do not switch off the power while the printing head is lowered.

Doing so may damage the head and impair printing performance.

PlatenRibbon cartridge

Printing head is lowered

• When the unit is not in use, keep the pinch rollers raised. The pinch rollers may be deformed if left engaged.

• If you do not intend to use the unit for an extended period of time, disconnect the unit from the power outlet.

Press the side of

the switch marked

with “

”.

Carriage position when

switching off the power

When the SETUP key is pressed to release

the setup state, the carriage moves to the

position shown in the figure, then stops.

Switch off the power when the carriage is at

this position.

1 3

Hold down the key on the panel

while you turn the power on.

Operations is normal if the figure shown at below.

Install a blade and ribbon cartridge

in the PC-50.

Performing a cutting test.

Load the material, and press the SETUP key.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

No comments

Roland PC-50 User Manual Page 15