Roland SJ-600 User Manual download pdf (Page 100)

Chapter 5 What to Do If

5-6 The Print Heads Stopped Moving

If the print-head carriage stops over the platen, take

action immediately to prevent the heads from dry-

ing out.

What to Do First

Switch the sub power off, then back on again. (If the

media is jammed, then also remove the media.) If the

heads move to the standby position (inside the right side

cover), it means the operation has ended successfully.

If the heads did not move, try switching off the main

power, then again switching on the main power, followed

by the sub power.

If the Heads Still Do Not Move

If the heads still do not move, carry out the following

emergency response measure, then contact your autho-

rized Roland DG Corp. dealer or Roland DG Corp. ser-

vice center.

1. Switch off the main power and detach the right side

cover.

2. Open the front cover.

3. Gently move the print heads by hand as far as the

standby position.

4. Insert the cap-unit tool into the hole at the bottom of

the machine and turn gently. The cap unit rises.

5. Make the guides at the edges of the print heads line

up with the printing heads at the edges of the cap

unit. Turn the tool further to bring the heads near the

cap unit.

6. When the heads make contact with the cap unit, turn

the tool one or two more turns.

Make sure the print heads are capped tightly.

Cap-unit tool

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 115 116

No comments

Roland SJ-600 User Manual Page 100