Roland VersaCamm VP-540i Specifications download pdf (Page 46)

Chapter 2 Operation

2-6 Performing Cutting

To Perform Cutting

To perform cutting, carry out the procedure described below.

➢Move the media clamps to locations where they don’t clamp the media. Alternatively, remove the

media clamps.

➢When you're performing cutting only, then if you're cutting roll media, allow the media to hang

down from the rear of the machine.

If cutting is started without doing this first, a motor error may occur or the roll may fall because the media is

pulled with excessive force.

Important Notes on Cutting

➢Never use the media clamps. You can also detach them when not in use.

☞ P. 81, "Printing Media That Warps Easily"

➢When you’re performing printing followed immediately by cutting, then before you start cutting, allow the ink

to dry sufficiently. Use your software RIP to make the setting for the drying time. For information on how to

make the setting, refer to the documentation for the software RIP you're using. The drying time varies accord-

ing to the media.

Media clamps

Turn the media flanges by hand to

pull out the necessary length from

the roll.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 135 136

No comments

Roland VersaCamm VP-540i Specifications Page 46