Roland SC-7 User Manual download pdf (Page 50)

Chapter 2: Basic Operation

2-3 Loading Media

Separating the Media

Make sure the [SETUP] LED lights up.

To cut off a printed portion from the roll, hold down the [SHEET CUT] key for at least one second. The piece is cut off

at the present location of the printing-start line. This step is not necessary when cutoff is performed automatically by

sending a media-cutoff command from the computer.

Removing the Media

Refer to the previous section, "Separating the

Media," and cut off the media.

When the SETUP LED is lighted, hold down

the [SETUP] key for at least one second.

Move the loading lever toward the back of the

unit.

The pinch rollers rise to release the media.

Remove the media.

Depending on the composition of the media, cutoff

may not be possible.

Depending on the composition of the media, media

may remain on the platen after cutoff. If this hap-

pens, remove it by hand.

When you're performing cutoff, do not use the [

] key to pull the media back. Unless the end of the

media has been pulled out to a location to the front

of the platen, cutoff may not be performed smoothly.

The SETUP LED goes out

Loading lever

Knife guide

Printed portion

The media is

cut off here.

Present location

of the blade tip

Downloaded From ManualsPrinter.com Manuals

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 134 135

No comments

Roland SC-7 User Manual Page 50