Roland XP-60 Owner's Manual download pdf (Page 5)

Important Notes

In addition to the items listed under “IMPORTANT SAFETY

INSTRUCTIONS” and “USING THE UNIT SAFELY” on

pages 2 and 3, please read and observe the following:

Power Supply

• Do not use this unit on the same power circuit with any

device that will generate line noise (such as an electric

motor or variable lighting system).

• Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

Placement

• Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum. To

alleviate the problem, change the orientation of this unit;

or move it farther away from the source of interference.

• This device may interfere with radio and television

reception. Do not use this device in the vicinity of such

receivers.

• Do not expose the unit to direct sunlight, place it near

devices that radiate heat, leave it inside an enclosed

vehicle, or otherwise subject it to temperature extremes.

Excessive heat can deform or discolor the unit.

• To avoid possible breakdown, do not use the unit in a wet

area, such as an area exposed to rain or other moisture.

Maintenance

• For everyday cleaning wipe the unit with a soft, dry cloth

or one that has been slightly dampened with water. To

remove stubborn dirt, use a cloth impregnated with a

mild, non-abrasive detergent. Afterwards, be sure to

wipe the unit thoroughly with a soft, dry cloth.

• Never use benzine, thinners, alcohol or solvents of any kind,

to avoid the possibility of discoloration and/or deformation.

Repairs and Data

• Please be aware that all data contained in the unit’s

memory may be lost when the unit is sent for repairs.

Important data should always be backed up memory

card, or written down on paper (when possible). During

repairs, due care is taken to avoid the loss of data.

However, in certain cases (such as when circuitry related

to memory itself is out of order), we regret that it may not

be possible to restore the data, and Roland assumes no

liability concerning such loss of data.

Memory Backup

• This unit contains a battery which powers the unit’s

memory circuits while the main power is off. When this

battery becomes weak, the message shown below will

appear in the display. Once you see this message, have

the battery replaced with a fresh one as soon as possible

to avoid the loss of all data in memory. To have the

battery replaced, consult with your retailer, the nearest

Roland Service Center, or an authorized Roland

distributor, as listed on the “Information” page.

“Battery Low”

Additional Precautions

• Please be aware that the contents of memory can be

irretrievably lost as a result of a malfunction, or the

improper operation of the unit. To protect yourself against

the risk of loosing important data, we recommend that

you periodically save a backup copy of important data

you have stored in the unit’s memory on a memory card.

• Unfortunately, it may be impossible to restore the

contents of data that was stored in the unit’s memory, a

memory card or another MIDI device (e.g., a sequencer)

once it has been lost. Roland Corporation assumes no

liability concerning such loss of data.

• Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its

jacks and connectors. Rough handling can lead to

malfunctions.

• Never strike or apply strong pressure to the display.

• When connecting / disconnecting all cables, grasp the

connector itself—never pull on the cable. This way you

will avoid causing shorts, or damage to the cable’s

internal elements.

• A small amount of heat will radiate from the unit during

normal operation.

• To avoid disturbing your neighbors, try to keep the unit’s

volume at reasonable levels. You may prefer to use

headphones, so you do not need to be concerned about

those around you (especially when it is late at night).

• When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise,

you will need to use equivalent packaging materials.

• Use only the specified expression pedal (EV-5; sold

separately). By connecting any other expression pedals,

you risk causing malfunction and/or damage to the unit.

Before Using Memory Cards

Using Memory Cards

• Carefully insert the Memory card all the way in—until it

is firmly in place.

• Never touch the terminals of the Memory card. Also,

avoid getting the terminals dirty.

Handling CD-ROMs

• Avoid touching or scratching the shiny underside

(encoded surface) of the disc. Damaged or dirty CD-ROM

discs may not be read properly. Keep your discs clean

using a commercially available CD cleaner.

1 2 3 4 5 6 7 8 9 10 ... 215 216

Comments to this Manuals

No comments

Roland XP-60 Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Digital pianos Roland XP-60