Roland SYS-553 Owner's Manual download pdf (Page 73)

Troubleshooting

The movie doesn’t stop

Is the Play Mode set to play back in a loop?

→

If the Play Mode is set to “Forward Loop” or “Alternate Loop,” then playback repeats

until you press the [EXIT] button.

p. 43

Is the Play Mode set to “One Shot 1”?

→

If the Play Mode is set to “One Shot 1,” then after the movie has finished, the last

frame remains on the screen and play back stops.

To clear the display on the screen, press the [EXIT] button.

p. 43

Are you controlling the P-10 from an external MIDI device using Program Change while

the Play Mode is set to “Gate1” or “Gate2”?

→

If you are controlling the P-10 from an external MIDI device using Program Change

while the Play Mode is set to “Gate1” or “Gate2,” then the movie is played back

continuously. Change the Note Message Enable setting to either “49 Keys” or

“Assignable,” and then control the P-10 using Note Message.

p. 43

p. 60

There is no sound

Is the audio cable connected correctly?

→

Check the cable connection.

p. 18

Is the audio volume turned down?

→

Rotate the [AUDIO VOLUME] knob to specify an appropriate audio level.

p. 14

The volume level of the

instrument connected to the

P-10 is too low

Is the input level set too low?

→

Rotate the [INPUT LEVEL] knob to adjust the setting to an appropriate level.

p. 59

Could you be using a connection cable that contains a resistor?

→

Use a connection cable that does not contain resistor.

–

The audio contains noise or the

sound is distorted

Is the audio input level set appropriately when you capture images?

→

If the input level is set too high, the sound is distorted. Conversely, if the input level is

set too low, it will sound like the audio contains noise. Rotate the [INPUT LEVEL] knob

to adjust the input level.

p. 59

Is the [SPEED] knob centered?

→

When you increase the playback speed, the audio may sound like noise because its

playback speed is also increased.

p. 28

The audio and images are not

in sync

Is Audio Sync set to “OFF”?

→

Set Audio Sync to “ON.”

p. 44

Have you added an audio file?

→

If the lengths of the audio and the images are different, then they will not be in sync.

→

The [REPEAT A B] button doesn’t work for audio files that you have added.

p. 44

p. 46

When playing back movies on the P-10, a jump of 1 frame about every 100 seconds

occurs (when using NTSC).

–

When the synchronized signal included in an input image is abnormal, the sound and

image recording may be misaligned.

–

When playing back a movie that was captured with the P-10 on a computer, the audio

and images on longer movies may be misaligned.

–

Problem

Cause/Solution Page

P-10_e.book 73 ページ２００８年７月１６日　水曜日　午後８時２３分

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 83 84

Comments to this Manuals

No comments

Roland SYS-553 Owner's Manual Page 73

Comments to this Manuals

Related products and manuals for Sequencer Roland SYS-553