Roland VK-7 Owner's Manual download pdf (Page 47)

Advanced Use

Edit mode allows you to get the most out of the VK-8’s

functions by making more detailed settings. This section

explains the functions that can be set in Edit mode. In this

owner’s manual, the process of modifying a setting is

referred to as “editing,” and the item of data that is modified

is referred to as a “parameter.”

■

About the Edit Modes

There are two edit modes—one saves settings individually

for each preset, while the other stores a single value to be

used by the entire system.

System Memory

The edit mode that stores things for the entire system deals

with the following:

• Organ rotary settings (p. 49)

• Click noise and percussion settings (p. 51)

• MIDI settings (p. 52)

• Equalizer and other settings (p. 55)

• Control pedal settings (p. 40)

Preset Memory

The edit mode that stores things on an individual preset

basis deals with the following:

• Effect and other settings (p. 56)

• Harmonic bars and other panel settings (p. 45)

• Split Point (p. 38)

• Active Expression setting (p. 39)

• OTHER TONES PART ASSIGN (p. 57)

NOTE

In the case of settings that are saved for each preset, you must

save the edited settings in a preset. If you turn off the power

without saving the edited settings to a preset, your changes will

be lost.

■

Basic Procedure

Here is the basic procedure for each edit mode.

→

For details, refer to the explanation for each edit mode.

Hold down the HARMONIC BAR PART [UPPER] and

[PEDAL] buttons, and press the [***] button.

The indicators of the [1]–[8] buttons will blink.

The [***] button will be a different button depending on

the edit mode that you want to set. For details, follow the

procedure for each edit mode.

Press one of the buttons from [1] through [8] to select

the parameter that you want to edit.

If there are more than eight parameters, you can access

all of them by switching the lit/dark state of the

[PRESET] button.

Turn the [VIBRATO AND CHORUS] knob to adjust

the setting.

For parameters that are switched ON/OFF, turn the

[VIBRATO AND CHORUS] knob toward the right to

switch the parameter ON, or toward the left to switch it

OFF.

For parameters that have an adjustable value, turn the

[VIBRATO AND CHORUS] knob toward the right to

increase the value, or toward the left to decrease the

value.

At this time, the D Beam type indicator will show the

approximate value of the setting (p. 48).

If you press the VIBRATO AND CHORUS [ON] button,

the setting will return to the initial value.

If you want to adjust another parameter in the same

edit mode, press one of the [1]–[8] buttons to select the

parameter, and turn the [VIBRATO AND CHORUS]

knob to edit the value.

When you want to stop editing, press the HARMONIC

BAR PART [UPPER] button.

Press the [WRITE] button to finalize the settings of the

parameters.

Parameter settings will be saved.

While the parameters are being saved, the indicators of

the [1]-[8] button will blink.

Parameters that are edited independently for each

preset are saved as part of the preset (p. 45).

VK-8_e.book 47 ページ２００５年７月２５日　月曜日　午後４時２４分

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 83 84

Comments to this Manuals

No comments

Roland VK-7 Owner's Manual Page 47

Comments to this Manuals

Related products and manuals for Mixers Roland VK-7