Roland XP-60 Owner's Manual Page 33
- Page / 248
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
❚
Playing in Rhythm Set mode
In Rhythm Set mode, you can play percussion instruments
(Rhythm Tones) on the keyboard. As the Rhythm Tone
assigned to each key varies by the Rhythm Set selected, you
can play a wide range of percussion instruments.
Selecting a Rhythm Set
The XP-80 offers five groups of Rhythm Sets (User, Presets
A–C and GM) with each group having two Rhythm Sets – a
total of 10 Rhythm Sets. In addition, up to four optional
Wave Expansion Boards can be installed for accessing even
more percussion instruments.
USER
The XP-80’s user memory contains two Rhythm Sets that can
be rewritten to make up your own Rhythm Sets.
PR-A–C (Presets A–C)
The XP-80 includes six preset Rhythm Sets that are not user-
rewritable. But you can call up preset Rhythm Set settings
into the temporary area, modify them, and then store them
in user memory.
GM (General MIDI)
GM Rhythm Sets are for instruments compatible with the
General MIDI System intended to standardize MIDI specifi-
cations among different equipment makers or models. The
XP-80 offers two GM Rhythm Sets that are not user-
rewritable. But you can call up GM Rhythm Set settings into
the temporary area, modify them, and then store them in
user memory.
XP-A–D (Wave Expansion Boards installed in EXP-A–D Slots)
These Rhythm Sets are included in optional Wave Expansion
Boards and are not user-rewritable. But you can call up
Rhythm Set settings into the temporary area, modify them,
and then store them in user memory.
✳ A Patch XP-A–D cannot be accessed if the Wave
Expansion Board it belongs to has not been installed.
<Procedure>
❶ Press [RHYTHM] to call up the Play display
(RHYTHM).
❷ Turn the VALUE dial or press [INC]/[DEC] to select a
Rhythm Set.
Selecting a Rhythm Set with Bank/Number method
You can select a Rhythm Set by combining BANK [1]–[8]
and NUMBER [1]–[8] located at front panel center. This is
called ‘Bank/Number method.’ However, when you select a
Rhythm Set stored in the XP-80, Bank is fixed at 1. So specify
the number by pressing NUMBER [1] or [2] only.
The bank/number corresponding to each Rhythm Set num-
ber is shown at the upper left of the display for your refer-
ence when selecting a Rhythm Set using the Bank/Number
method.
Rhythm Set number: 001 002 .... 008
Bank/number: a11 a12 ... a18
<Procedure>
❶ Press [RHYTHM] to call up the Play display
(RHYTHM).
❷ Turn the VALUE dial, or press [INC]/[DEC] or numer-
ic keys to select a Rhythm Set group.
❸ Press NUMBER [1]–[8] to select a number.
✳ When selecting a Rhythm Set from a Wave Expansion
Board, a bank and su/jointfilesconvert/383009/bgroup may have to be specified.
For details, refer to the Owner’s Manual for optional
Wave Expansion Boards.
Rhythm set
group
Rhythm set
number
Rhythm set
name
MIDI channel
Rhythm set
number
Bank/Number
33
Chapter 2. Playing
- OWNER’S MANUAL 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- SAVE THESE INSTRUCTIONS 2
- IMPORTANT NOTES 4
- Protect tab 5
- Write (writing permitted) 5
- Protect (writing prohibited) 5
- Features of the XP-60/XP-80 6
- Chapter outlines 7
- Contents 8
- Front panel 14
- I. SEQUENCER section 15
- Side panel 16
- Rear panel 17
- XP-80 configuration 18
- Performances 19
- Rhythm Sets 19
- Basic operation 20
- VALUE dial 23
- [INC] and [DEC] 23
- [0]–[9] (Numeric Keys) 23
- Chapter 2. Playing 26
- Changing sound characters 28
- Playing in Performance mode 29
- (Sound Palette) 32
- Playing in Rhythm Set mode 33
- Rhythm Set 34
- Playing an arpeggio 35
- Recording an arpeggio 37
- (Octave Shift) 37
- Regarding effects 39
- Sound editing procedures 40
- Note on Tone editing 42
- Editing a Performance 43
- Part number 44
- MIDI channel 44
- Keeping edited sound 45
- Functions of Patch parameters 46
- Common Control display 47
- Structure display 49
- Pitch display 52
- Pitch Envelope display 53
- TVF Envelope display 54
- Time 1 Time 2 Time 3 Time 4 56
- (LFO2 parameter) display 57
- Ext Sync (LFO external sync) 57
- Control Switch display 59
- EFX Type name 60
- Chorus display 64
- Reverb display 64
- Settings common to the entire 65
- Performance (Common) 65
- [PERFORM]➞[F1] (Common) 65
- Lower Upper 66
- Key range specified for Patch 66
- [PERFORM]➞[F4] (MIDI) 67
- [PERFORM]➞[F5] (Effects) 68
- [PERFORM]➞[F6] (Info) 69
- Naming a Rhythm Set (Common) 70
- Rhythm Tone (Key WG) 70
- [RHYTHM]➞[F3] (Key TVF) 71
- TVA Envelope display 72
- Bend Range (Pitch bend range) 72
- Mute Group 72
- [RHYTHM]➞[F5] (Key Ctl) 73
- 2: OVERDRIVE 74
- 3: DISTORTION 74
- 4: PHASER 75
- 5: SPECTRUM 75
- 6: ENHANCER 75
- 7: AUTO-WAH 76
- 8: ROTARY 76
- 9: COMPRESSOR 76
- 10: LIMITER 77
- 11: HEXA-CHORUS 77
- 12: TREMOLO-CHORUS 77
- 13: SPACE-D 78
- 14: STEREO-CHORUS 78
- 15: STEREO-FLANGER 78
- 16: STEP-FLANGER 79
- 17: STEREO-DELAY 79
- 18: MODULATION-DELAY 80
- 19: TRIPLE-TAP-DELAY 80
- 20: QUADRUPLE-TAP-DELAY 81
- 21: TIME-CONTROL-DELAY 82
- 22: 2VOICE-PITCH-SHIFTER 82
- 24: REVERB 83
- 25: GATE-REVERB 84
- 26: OVERDRIVE ➞ CHORUS 84
- 27: OVERDRIVE ➞ FLANGER 84
- 28: OVERDRIVE ➞ DELAY 85
- 29: DISTORTION ➞ CHORUS 85
- 30: DISTORTION ➞ FLANGER 85
- 31: DISTORTION ➞ DELAY 85
- 32: ENHANCER ➞ CHORUS 85
- 33: ENHANCER ➞ FLANGER 86
- 34: ENHANCER ➞ DELAY 86
- 35: CHORUS ➞ DELAY 86
- 36: FLANGER ➞ DELAY 87
- 37: CHORUS ➞ FLANGER 87
- [SYSTEM]➞[F1] (Setup) 88
- Adjusting tuning (Tune) 89
- [SYSTEM]➞[F2] (Tune) 89
- MIDI settings (MIDI) 90
- [SYSTEM]➞[F3] (MIDI) 90
- [SYSTEM]➞[F4] (Control) 92
- Arpeggio settings (Arpeg) 93
- [SYSTEM]➞[F5] (Arpeg) 93
- [SYSTEM]➞[F6] (Info) 95
- About the sequencer 96
- Playing back a song 97
- (Quick Play) 98
- Reserve 1 99
- Reserve 2 99
- Reserve 3 99
- Playing back a Pattern 101
- Before you start to record 104
- Selecting instrument sounds 105
- Setting the time signature 105
- Performing realtime recording 108
- (Realtime Erase) 110
- Recording tempo changes 110
- Canceling recording (Undo) 112
- Inputting data step by step 113
- (Step recording) 113
- Inputting chords 114
- Inputting ties 114
- Inputting a dotted note 114
- Inputting rests 114
- Erasing wrong notes 114
- Deleting recording (Undo) 115
- Saving only a song 116
- Chapter 5. Editing a song 117
- Settings for an entire song 118
- Locate function 119
- Setting loop 120
- [SEQUENCER]➞[F5] (Loop) 120
- About Track Edit 121
- [SEQUENCER]➞[F3] (TrkEdit) 121
- Setting the editing area 122
- Copying a phrase – 3 Copy 124
- (Insert measure) 126
- (Change velocity) 127
- (Change MIDI channel) 128
- (Change gate time) 129
- Aligning a song’s timing 136
- (Quantize) 136
- Grid quantize 137
- Shuffle quantize 138
- Groove quantize 139
- Phrase track/Pattern 146
- [SEQUENCER]➞[F4] (Micro) 146
- Erasing sequencer data 149
- Moving sequencer data 149
- Copying sequencer data 149
- Getting ready to use RPS 150
- Playing using RPS 151
- Getting ready for Chain Play 153
- Saving a chain to disk 154
- Chain play 154
- About Utility mode 155
- Performance write 156
- Patch write 156
- Rhythm Set write 156
- [UTILITY]➞[1]➞[ENTER] 156
- Performance copy 157
- [UTILITY]➞[2]➞[ENTER] 157
- Patch copy 158
- Rhythm Set copy 159
- – 3 Initialize 160
- 4 Data Transfer 161
- [UTILITY]➞[4]➞[ENTER] 162
- [UTILITY]➞[5]/[6]/[7]➞[ENTER] 164
- – 8 Factory (Factory preset) 165
- About Disk mode 166
- XP-80 – 1 Load 167
- Saving data to disk – 2 Save 168
- Formatting the disk for the 169
- XP-60/XP-80 – 3 Format 169
- 5 Verify 170
- Changing the name of disk – 170
- Deleting unwanted files – 171
- 7 Delete (Delete file) 171
- Renaming a file – 8 Rename 171
- 9 Info (Disk information) 172
- Entering GM mode 173
- Modifying GM mode settings 174
- [SHIFT]+[PERFORM]➞[F6] (Info) 175
- (GM Utility) 176
- Transfer (GM Data Transfer) 177
- Techniques for using Patches 178
- Using the XP-80 to play live 179
- Song making techniques 180
- Changing the Patch 181
- Changing the Performance 181
- Changing the Rhythm Set 181
- Using external MIDI devices 182
- Synchronization with external 183
- MIDI devices 183
- Disk Recorder 184
- Playing back Song files 185
- Recording on the VS-880 185
- MIDI OUT 186
- MIDI OUTMIDI IN 186
- Troubleshooting 187
- Error messages 188
- Parameter List 190
- WG Group 191
- TVF Group 191
- TVA Group 192
- LFO&Ctl Group 192
- Effects Group 193
- Performance Parameters 194
- Rhythm Set Parameters 195
- Key TVF Group 196
- Key TVA Group 196
- Key Ctl Group 196
- GM Parameters 197
- Info Group 198
- EFX Parameters 199
- 39: FLANGER/DELAY (P.88) 203
- 40: CHORUS/FLANGER (P.88) 203
- System Parameters 204
- Control Group 205
- Arpeg Group 205
- Factory Preset Settings 206
- INT-B (Internal B) 207
- Patch List 208
- GM (GM Group) 210
- Rhythm set List 211
- Performance List 212
- Arpeggio style list 213
- MIDI implementation 214
- ■ Channel Mode messages 216
- ■ System Realtime messages 217
- ■ System Exclusive messages 217
- ■ Channel Voice messages 218
- ■ Channel voice messages 219
- 1-1-1.System Common 222
- 1-1-2.Scale Tune 222
- 1-2.Performance 222
- 1-2-1.Performance Common 223
- 1-2-2.Performance Part 223
- 1-3.Patch 223
- 1-3-1.Patch Common 223
- 1-3-2.Patch Tone 224
- 1-4.Rhythm Setup 225
- 1-4-1.Rhythm Common 225
- 1-4-2.Rhythm Note 225
- ■ Address block map 226
- 2.GS (Model ID = 42H) 226
- 2-1.Scale Tune 226
- 6. Supplementary material 226
- Thus, the address is: 227
- 00 00H Patch Common 228
- MIDI Implementation Chart 229
- Specifications 231
- Quick reference of displays 232
- Performance mode [PERFORM] 233
- Rhythm Set mode [RHYTHM] 234
- GM mode [SHIFT] + [PERFORM] 235
- Sequencer mode [SEQUENCER] 236
- Chain Play mode [CHAIN PLAY] 238
- System mode [SYSTEM] 238
- Utility mode [UTILITY] 239
- Disk mode [DISK] 240
- Information 246
Related products and manuals for Musical Instruments Roland XP-60
Musical Instruments Roland RP101 User Manual
(52 pages)
(52 pages)
Musical Instruments Roland RS-70 User Manual
(178 pages)
(178 pages)
Musical Instruments Roland RP201 User Manual
(60 pages)
(60 pages)
Musical Instruments Roland HP 557R User Manual
(140 pages)
(140 pages)
(11 pages)
Musical Instruments Roland FP-3 User Manual
(64 pages)
(64 pages)
MGE UPS Systems 30A manuels
Manuels d'utilisation et guides de l'utilisateur pour Unités d'alimentation électrique MGE UPS Systems 30A.
Nous fournissons des manuels en pdf 2 MGE UPS Systems 30A à télécharger gratuitement par type de document : Manuel de l'utilisateur
Comments to this Manuals