Roland XP-60 Owner's Manual Page 88

  • Download
  • Add to my manuals
  • Print
  • Page
    / 248
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 87
88
38: CHORUS/DELAY
This effect connects a chorus and a delay in parallel. The
parameters are the same as for 35: CHORUS DELAY.
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
39: FLANGER/DELAY
This effect connects a flanger and a delay in parallel. The
parameters are the same as for 36: FLANGER DELAY.
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
40: CHORUS/FLANGER
This effect connects a chorus and a flanger in parallel. The
parameters are the same as for 37: CHORUS FLANGER.
However, the Flanger Balance parameter adjusts the volume
balance between the direct sound and the flanger sound.
XP-80 operating environment setup
(System parameters and their functions)
System mode settings will be retained until they are
reset the next time.
Setups and keyboard settings (Setup)
Setup display
This display is used when you adjust display brightness and
set keyboard touch, etc.
LCD Contrast
Adjusts display screen contrast (brightness). Higher values
make display brighter.
Patch Remain (Patch remain switch)
Specifies whether you want the notes that are sounding to
remain (ON) or turn off (OFF) when you select a new Patch
or Rhythm Set.
Power Up Mode
Specifies how you want the state of the XP-80 when power is
turned on.
LAST-SET: The XP-80 remains in the state it was when
power was turned off.
DEFAULT: The XP-80 will be ready to play Patch USER:001.
Character Style
Selects large character type (for Patch names, file names,
etc.) shown on each modes Play display.
TYPE 1: Bold characters of equal width
TYPE 2: Light characters of equal width
TYPE 3: Bold characters of differing widths
TYPE 4: Light characters of differing widths
Transpose Value
If you wish to transpose the range of the keyboard, this para-
meter specifies the transpose amount in semitones. Tonic is
indicated in parentheses ( ).
When transposing the keyboard range, press [TRANS-
POSE] and indicator lights.
The octave-shift amount and the transpose amount are
shown at lower left in each sources Play display.
To change transpose amount on a Play display, hold
down [TRANSPOSE] and press [-OCT] or [+OCT].
R in R out
L in L out
Feedback
Balance W
Balance D
Balance W
Balance D
Chorus
Delay
R in R out
L in L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
Flanger
Delay
R in R out
L in L out
Feedback
Balance W
Balance D
Balance W
Balance D
Chorus
Flanger
Chapter 3. Creating your own sounds
[SYSTEM][F1] (Setup)
Page view 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 247 248

Comments to this Manuals

No comments