Roland SJ-600 User Manual download pdf (Page 32)

Setup for Printing

Remove the left-hand media flange at the back of the

unit.

Move the right-hand media flange at the back of the unit

to a position where it does not touch the loaded material.

Front

Pass the material between the pinch rollers and the grit

rollers.

Sheet material

Line up the right-hand side of the material with the

guide line, and line up the front edge of the material

with the reflective tape.

If the front edge of the material has been cut at an

angle, pull out the material so that all of the material

covers the reflective tape.

* Be sure to line up the right-hand edge of the material

with the guide line.

If the material is not positioned correctly when you

press the [SETUP] key, the message "SET AGAIN"

appears on the display.

Front

Guide line

Reflective tape

Material

Drape the pulled-out portion at the back between the

unit and the media guide.

Move the sheet loading lever toward "LOAD".

The pinch rollers lower to hold the material in place.

Sheet loading lever

Close the front cover, and press the [SETUP] key.

This detects the width of the material and displays the

printable width.

The SETUP LED lights up

W 300 mm

NORMAL BI-DIR

Top menu

Media guide

Loading Sheet Material

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 76 77

No comments

Roland SJ-600 User Manual Page 32