Roland SJ-600 User Manual download pdf (Page 59)

User's Reference

Adjusting the Height of the Printing Head

You adjust the height of the printing head to match the thickness of the mounted material. You can adjust the head height by moving the

lever shown in the figure to any of the positions (1 through 3), where it clicks into place.

The height of the printing head may normally be left set at 3. If the loaded material is thin, lowering the height to the 1 or 2 position may

produce better printing results.

Attach the cover on the machine.

For information on how to attach the cover, refer to the Cleaning Kit User's Manual -- "Performing Cleaning," step 22.

Move the lever to adjust the height of the printing head.

* Be sure that the carriage

is in standby position

before attempting to

move the lever.

Height of the printing head

High

Low

Lever

Detach the cover from the machine.

For information on how to detach the cover, refer to the Cleaning Kit User's Manual that comes with the cleaning kit. See

"Performing Cleaning," steps 1 through 3.

Before you begin the task, be sure to read the cautions printed on the cleaning kit.

When the height of the printing head has been adjusted, it is necessary to perform bidirectional correction (only when

the printing direction for [PRINT MODE] has been set to [BI-DIRECTION]). For more information about bidirec-

tional correction, see "User's Reference -- Making Corrections for Printing -- Bidirectional Correction."

Do not attempt to lower the printing head when any of the following kinds of material is loaded.

The head may strike the material during printing, resulting in a paper jam or causing breakdown or faulty

operation.

-Thick material

-Material that may come loose or warp during printing

NOTICE

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 76 77

No comments

Roland SJ-600 User Manual Page 59