Roland SJ-600 User Manual download pdf (Page 58)

User's Reference

Setting the Page Margins

This makes the setting for the margin between pages.

When outputting a number of pages continuously, you can establish a margin between the pages.

You can set this in a range of 0 mm to 100 mm (in 10 mm steps).

This is set at 20 mm when shipped from the factory.

[

When the material-cutting command is enabled

]

Start of the next output

End of output

Margin (value set for [PAGE MARGIN])

Start of the next output

End of output

Margin (value set for [PAGE MARGIN])

Location where separated

10 mm

(3/8 in.)

10 mm (3/8 in.)

[

When the material is not cut off

]

Press the [MENU] key and [ ] key to make the

following screen appear on the display.

Press the [ ] key to make the following screen

appear on the display.

Use the [ ] and [ ] keys to set a margin, then press

the [ENTER] key.

PAGE MARGIN

20mm 20mm

0 to 100 mm

(In steps of 10 mm)

PAGE MARGIN

20mm 10mm

10 mm (3/8 in.)

When separating the material with the margin set at [0], the position where the material is separated and the end of

printing may not match.

When performing continuous printing with the margin set at [0], image quality just after starting to print may be poor on

the second page or after. Also, dot drop-out or overlap may occur at the page borders.

When you use the program to set the page margins, the program’s settings take priority. The setting made with the

control panel for the machine takes effect only in cases where the settings for page margins are not made with the

program.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 76 77

No comments

Roland SJ-600 User Manual Page 58