Roland SJ-600 User Manual download pdf (Page 38)

Cut the Material From the Roll

Either of two methods can be used to separate a portion that's already been cut or printed from the roll. One method is to press the

[SHEET CUT] key. The other method is to perform separation automatically by sending a material-cutting command from the computer.

Remove the Material From the Machine

When separating the material by pressing the [SHEET CUT] key

Remove the Material

Press the [SETUP] key. Hold down for about 1

second or longer.

The SETUP LED goes out

Move the sheet loading lever toward the back of the

unit.

The pinch rollers rise to release the material.

Sheet loading lever

Open the front cover to remove the material.

Holding down the [SHEET CUT] key for 1 second or longer

severs the material at the present location of the blade tip.

Present location of

the blade tip

Printed portion

The material is cut off here.

Remove the Material

* This operation isn't necessary when

sending a material-cutting command

from the computer to separate the

material automatically.

If you wish to cut off the piece of the rolled material

containing the printed area, press the [SHEET CUT]

key. Hold down for about 1 second or longer.

The piece is cut off at the present location of the

printing-start line.

* This operation isn’t

necessary when sending a

material-cutting command

from the computer to

separate the material

automatically.

Printing-start line

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 76 77

No comments

Roland SJ-600 User Manual Page 38