Roland SJ-600 User Manual download pdf (Page 33)

When you are loading material whose left and right edges are prone to warping, use the media clamps. At such times, perform printing

with the printing heads positioned at "3" (high). For more information about the height of the printing heads, refer to "User's Reference -

- Adjusting the Height of the Printing Head."

Line up the holes in the media clamps with the left and

right edges of the material. At this time, loosen the

screws on the media clamps, but do not loosen them so

much that they come off completely.

Installing the Media Clamps

Insert the media clamps into the grooves as shown in the

figure.

Tighten the screws to secure the media clamps in

place.

Media clamp

Groove

Material

Screw

Material

Media clamps

Screws

Holes

Insert this portion.

Insert the media clamp in the

same way at the left edge of

the material as well.

- When you are using the media clamps, attempting to cut off the material causes the material to come loose from the

media clamps. If this happens, reinstall the media clamps.

- When you are not using the media clamps, remove them from this machine.

- As printing proceeds, the material may move to the left right and touch or come loose from the media clamps. After

about 1 m (39-3/8 in.) of material has been fed, check the positioning of the media clamps. If the material looks like

it may come loose from the media clamps, adjust the positioning of the media clamps.

- The media clamps are designed to press down on a space 10 mm (7/16 in.) inward from either edge of the material.

Do not perform printing within these areas.

Loading Material Prone to Warping

Setup for Printing

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 76 77

No comments

Roland SJ-600 User Manual Page 33